Download Print this page

Pedal Parts Mange Raster Dallas Rangemaster Germanium Treble Boost Manual

Advertisement

Quick Links

Mange Raster
Dallas Rangemaster
Germanium Treble Boost
PedalParts.co.uk

Advertisement

loading
Need help?

Need help?

Do you have a question about the Mange Raster Dallas Rangemaster Germanium Treble Boost and is the answer not in the manual?

Questions and answers

Summary of Contents for Pedal Parts Mange Raster Dallas Rangemaster Germanium Treble Boost

  • Page 1 Mange Raster Dallas Rangemaster Germanium Treble Boost PedalParts.co.uk...
  • Page 2 Schematic Schematic above is for NPN / negative ground version, based on the Range Blaster modifications at Fuzz Central. 470K The original used PNP / positive BIAS 100K preset ground supply. To convert for PNP, simply reverse the orientation of D1, C2, C3, and hook up the power in reverse as shown on the PNP wiring page further on.
  • Page 3 Wiring shown overleaf will disconnect the battery when you remove the jack plug from the input, and also when a DC plug is inserted. Snap the little metal tag off the pot to mount it flush in the box. You MUST use some kind of heat sink on the legs of the transistors when soldering.
  • Page 4 Test the A A T board! Once you’ve finished the circuit it makes sense to test is before starting on the switch and LED wiring. It’ll cut down troubleshooting time in the long run. If the circuit works at this stage, but it doesn’t once you wire up the switch - guess what? You’ve probably made a mistake with the switch.
  • Page 5 PNP cans? Follow this. BOARD BOARD INPUT BOARD BOARD BOARD BOARD BATTERY BOARD PNP CANS? Ooh, many, but how about: AC128 2N404 The Board GND connections don’t all have to directly attach to the board. You can run a couple of wires from the DC connector, one to the board, another to the IN jack, then daisy chain that over to the OUT jack.
  • Page 6 NPN cans? Follow this. BOARD BOARD INPUT BOARD BOARD BOARD BOARD BOARD NPN CANS? BOARD BATTERY Ooh, many, but how about: AC176 The Board GND connections don’t all have to directly attach to the board. You can run a couple of wires from the DC connector, one to the board, another to the IN jack, then daisy chain that over to the OUT jack.