Direct Tuning - Sony ICF-SW1000TS Operating Instructions Manual

Various tuning methods for optimum reception (continued)

Direct tuning

When the desired broadcast station is known,
enter the frequency with the numeric buttons
for immediate selection.
Tips
• When you have entered
the wrong frequency in
step 4, press DIRECT to
cancel the current entry
and enter the correct
frequency.
• "TRY AGAIN!" flashes
when the frequency
entered is invalid and
beyond the allocated
frequency range for
reception. Check and
make sure that the
frequency is valid and
repeat from step 3
again.
• The minimum digit
entry is 0.05 MHz (50
kHz) for the FM band,
and 1 kHz for the AM
band.
Note
Complete each button
operation in steps 3 to 5
within 10 seconds. If
the previously tuned
frequency appears in
the display, repeat from
step 3 again.
14 EN
Radio
RADIO POWER ON/OFF
FM/AM
1
Turn on the radio.
2
Select either FM or AM.
Select AM to listen to SW, MW or LW.
3
Press DIRECT.
The frequency in the display disappears.
4
Enter the frequency of the desired broadcast
station by pressing the numeric buttons.
FM band: A decimal point is not required for entry.
For example, to enter 84.7 MHz, press 8, 4 and 7.
AM band: The lower triple zero digits are omitted for
entry.
For example, to enter 10,000 kHz, press 1 and 0.
5
Press EXE.
When the desired broadcast station is received,
"
TUNE
1 2 3
4 5 6
7 8 9
0
DIRECT EXE
" appears in the display.
Numeric
buttons