Advertisement
Quick Links
Caution: You must read this before you proceed.
SPINDLE BACK CHAIR
WARNING: These chairs are intended only for normal use with all four chair legs on the ground.
These consumer chairs have relatively thin legs and are not designed to be sat in with only two
chair legs on the ground (as from tipping back, forward, or to the side), and such can cause stress
and failure of one or more chair legs. Any misuse of the chairs voids any warranties, express or
implied.
Page 1 OF 7
Advertisement
Related Manuals for Christopher Knight Home 302241
Summary of Contents for Christopher Knight Home 302241
- Page 1 Caution: You must read this before you proceed. SPINDLE BACK CHAIR WARNING: These chairs are intended only for normal use with all four chair legs on the ground. These consumer chairs have relatively thin legs and are not designed to be sat in with only two chair legs on the ground (as from tipping back, forward, or to the side), and such can cause stress and failure of one or more chair legs.
- Page 2 Part NO. Picture Description Chair / Seat 1 PC Left Leg Frame(Mark With 1 PC Right Leg Frame(Mark with 1 PC Middle Support Rail 1 PC JCBC Bolt(M6*50MM) 2 PCS Barrel Nut 2 PCS Screw(M7*35mm) 6 PCS Allen Key 1 PC Wood Button 2 PCS Foam Pad...
- Page 3 Before Beginning Assembly: Parts Introduction This Spindle Back Chair has multiple parts and may require up to 20 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various Chair parts into perspective.
- Page 4 Step 1 B. Right Leg Frame A. Chair/Seat D. Middle Support Rail C. Left Leg Frame Place the Chair/Seat(A) on a clean, non-marring surface. take out all of the Parts and Hardware. Step 2 Insert Barrel Nut(F) into the holes on Middle Support Rail(D),and use Screwdriver(L) to adjust the Barrel Nut(F) mounting position.
- Page 5 Step 3 Position the Leg Frame onto the bottom of Chair Seat(A). Align and attach Chair Back(A) and Leg Frame using Screws(G) with Screwdriver(L). Proceed to tighten all the bolts Note: Front Legs must be facing the front. Step 4 Adhere the Foam Pad(K) under the Legs.
- Page 6 Step 5 Stand the Spindle Back Chair rightside up. Insert the wood button(G) into the leg support raill screw Hole Your Spindle Back Chair is ready for use. Page 6 OF 7...
- Page 7 Page 7 OF 7...
Need help?
Do you have a question about the 302241 and is the answer not in the manual?
Questions and answers