Faults - Exquisit GSP206-030D Manual

Faults

17
Before you contact after-sales service
Error
Appliance is not
working.
Dishes are not dry or
not properly dry
Plastic tableware is not
properly dry
Cutlery is not dry
Interior sides of the
appliance are wet after
the wash cycle
Dishes are not properly
clean
POSSIBLE CAUSES
Fuse blown or fused circuit-
breaker tripped.
Plug is not plugged in to the
plug socket.
Low water pressure
Appliance door does not close
properly.
No rinsing agent used or
dosage set too low
The detergent used has a
poor drying performance
Selected programme has no
"Dry" function
The "Extra dry" function was
not activated.
Water collects in recesses in
the crockery or cutlery
Drying process was not yet
finished
Normal phenomenon.
Synthetic material dries
worse.
Cutlery incorrectly sorted
Normal phenomenon
• Dishes not properly
arranged
• Rotation of the spray
arms is blocked
Clogged nozzles of the spray
arms
Dirty filters
Remedy
Check fuses.
Plug the mains plug into the
plug socket.
Check whether the water
supply hose is correctly
connected and the tap is
properly turned on.
Close the appliance door.
1. Fill with rinsing agent
2. Regulate rinsing
agent quantity
Use rinsing agent or
combined detergent with
higher drying capacity
Select programme with
"Dry"
Activate the "Extra dry"
function, if available
Put dishes away at an angle
if possible
(see chapter 4.5 "Putting
away dishes and cutlery")
Wait until the programme
ends. Open the door a little
after the end of the
programme. Steam can
escape and the dishes dry
out.
No remedy possible (see
chapter 4.5 "Loading dishes
and cutlery")
Load cutlery correctly
No action necessary
Load the dishes and cutlery
basket without the spray
arms hitting them (see
section 4.5 "Loading dishes
and cutlery")..
Clean spray arms (see
chapter 6 "Cleaning and
maintenance")
Clean filter (see chapter 6
"Cleaning and
maintenance")
Faults