Table of Contents
Advertisement
Getting Started
Your plasma screen was tested and packed before
delivery. It is ready to for use after it has been
unpacked. After unpacking the screen, please check
for possible damages and completeness of the
delivery. In case there is a damage, the supplier may
only meet your demands after you inform them about
the situation before the first installation.
Attention: Always remove the screen from its
package with the help of a second person. Trying
to remove the screen from its package by yourself
is hazardous to your health.
Note: Scart, DVI, VGA and PHONO cables are not
supplied.
The contents of the cardboard box are:
1. plasma screen
2. Remote Control
3. Batteries
4. Mains lead
5. User's Manual
6. Guarantee Certificate
7. Quick set up guide
8. Table stand
9. Speakers
If there is any missing component in the package,
please call the Service Support Line. The missing
part will be sent to you free of charge. Please keep
this user's manual near the installation site to have
continuous assistance.
Installation site
A proper installation site must be in compliance with
the below criteria:
• Light reflections Avoid installing opposite of
windows or other light sources.
• Accessibility to mains input The mains input
and mains switch should be easily access›ble at
all times.
• Ventilation Keep minimum 10 cm clearance from
above and below the ventilation holes to the
furniture and the ceiling.
• Environment Temperature Safe operation should
be between 5ºC and 35ºC.
Starting
There are some procedures you should carry out
before turning on your plasma TV.
1. The connection of signal sources: TELEVISION,
VIDEO, COMPUTER
2. Sound playback connection
3. Insert the batteries in the remote control
4. Connect the mains lead
5. Turn the plasma screen on
Inserting the Connection Line
When connecting or inserting the mains lead and
video cable (e.g. SCART, Y/C...) the following points
should be taken into consideration:
• Please align the connection lines. Note that signal
lines are not placed directly on the surface of the
screen.
• For high image quality, use only covered high
quality signal cable. To connect video signal, high
quality 75
coaxial cable should be used. A
signal low-quality signal cable may cause
distortions and shadows on the displayed picture
as well as exceeding the permissible EMC level.
For perfect and safe operation of the device,
mechanical interlocks for single plug and outlet
sockets are necessary.
• You should also avoid placing signal sources such
as computer or video recording device in front of
the screen.
Please place these signal sources next to or
behind the screen.
• Always turn your plasma television off before
connecting any signal source to it.
The Connection of Signal Sources:
Connect the cables of your signal sources to the
input panel of your plasma screen.
You need an aerial cable for the built-in TV Tuner,
and a suitable PHONO cable for external audio
sources.
Sound Connection (playback)
Your plasma screen has various sound outputs on
the input panel for sound playback. It is possible to
connect your music set or Dolby Surround System
as well as external loudspeakers to your internal
amplifier.
• Turn your plasma screen off before connecting
external loudspeakers. Take into consideration
the technical data of loudspeakers' output and
make sure that the size of the loudspeakers is
sufficient.
• Before establishing a connection between you
music set or Dolby Surround system and your
plasma screen, always turn the device off.
-9-
Advertisement
Table of Contents
