Troubleshooting; Spare Parts - Watts ENWARE DET685 Installation And Maintenance Instructions Manual

troubleshooting

PROBLEM
Water leaking from outlet
Water dripping and does
not shut off
Water runs constantly from
basin outlet
Water is leaking from
spindle
Water is not flowing from
tap
Poor water flow from outlet
Push Button hard to
operate
Push button feels too
loose
Spring action does not
move

spare parts

PART
SBA – Spring Action - Button Action
Spring action SBA service kit
Includes 2x piston o-rings, 1x spring, 1x light spring, 1x ball bearing, 1x
ball seating washer, 1x seat o-ring, 1x red fibre washer
www.enware.com.au
CAUSE
Push button assembly
screwed too tightly into
connector.
SBA spindle has debris
caught in the mechanism.
SBA seating washer
damaged or spring broken
Piston jammed in open
position
O-ring on SBA is worn or
damaged
Water turned off.
Aerator / Flow control or SBA
is blocked by debris.
Water pressure too high
Push button assembly
screwed out too far
Push button assembly
incorrectly adjusted
Piston in SBA is seized
Page 7
RECTIFICATION
Re-Adjust connector as per top
assembly installation instructions
Remove SBA and inspect.
Remove debris and/or replace
SBA if damaged.
Install an inline strainer.
Dismantle and clean or replace
SBA.
Remove piston from SBA. Clean
piston assembly
Dismantle and clean piston from
SBA.
Replace SBA.
Turn water on.
Remove flow control or SBA and
clean debris.
Install an inline strainer.
Adjust working pressure to that
recommended
Re-Adjust connector as per top
assembly installation instructions
Clean piston and piston o-rings,
and re-grease. Use SBA service
kit BUB289. (See service and
maintenance)
ENWARE SALES CODE
BUB260B
BUB289
© Enware Pty Ltd