Self-Diagnosis - EUROLAMP TAC-12CHPB/DM3 Instructions Manual

ENG
INSTALLATION INSTRUCTIONS
SETTING THE TIMER
This timer can be used to delay the appliance start up or shutdown, this avoids wasting electricity
by optimizing operating periods.
Programming start-up
● Turn on the appliance, choose the mode you want, for example cool, 24
off the appliance.
● Press the button, the " Timer " symbol and number of hours flash.
● Press the " " / "
● Wait about 5 seconds, the timer will be active, the " Timer " symbol is light.
● Press again the Timer button
symbol will disappear from screen.
Programming shut down
● When the appliance is running, press the
flash.
● Press the " " / " " button until the corresponding time is displayed.
● Wait about 5 seconds, the timer will be active, the " Timer " symbol is light.
● Press again the Timer button
symbol will disappear from screen.
SWITCH THE UNIT OF TEMPERATURE
When the appliance is running, hold on "
time, then you can change the unit of temperature.
For example:
Before change, in cool mode, the screen display like fig1.
After change, in cool mode, the screen display like fig2.

SELF-DIAGNOSIS

The appliance has a self diagnosis system to identify a number of malfunctions.
Protection tips are displayed on the appliance display.
IF IS DISPLAYED
PROBE FAILURE
(sensor damaged)
FULL TANK
(safety tank full)
" button until the corresponding time is displayed.
or the button, the timer will be canceled, and the "Timer"
button, the " Timer " symbol and number of hours
or the button, the timer will be canceled, and the "Timer"
" and "
If this is displayed, contact your local authorize service centre.
Empty the internal safety tank, following the instructions in the
"End of season operations" paragraph.
-64-
C, high fan speed. Turn
o
" button together 3 seconds by the same
WHAT SHOULD I DO?