Page 1
This Owner's Manual is provided and hosted by Appliance Factory Parts. Everstar MPA-08CR Owner's Manual Shop genuine replacement parts for Everstar MPA-08CR Find Your Everstar Air Conditioner Parts - Select From 13 Models -------- Manual continues below --------...
PORTABLE AIR CONDITIONER INSTRUCTION MANUAL Read Rules for Safe Operation and Instructions Carefully.
Page 4
CAUTION Do not leave this unit unattended in a space where people or animals who cannot react to a failed unit are located. A failed unit can cause extreme overheating or death in such an enclosed, unattended space.
Page 5
Electrical Specifications 6. To avoid the possibility of personal injury, always 1. All wiring must comply with local and national disconnect the power supply to the unit, before electrical codes and be installed by a qualified installing and/or servicing. electrician. If you have any questions regarding the following instructions, contact a qualified Table 1 electrician.
Energy-Saving Tips This appliance is designed to be highly efficient 4) Start your air conditioner before the outdoor air n energy savings. Follow these recommendations becomes hot and uncomfortable. This avoids an for greater efficiency. initial period of discomfort while the unit is 1) Select a thermostat setting that suits your cooling off the room.
Window Kit Installation Your window kit has been designed to fit most Horizontal Window standard "vertical"and "horizontal" window applications. However, it may be necessary for you to improvise/modify some aspects of the installation procedures for certain types of Window Slider Kit windows.
Page 8
Key Pad Functions Fig.5 SWING: Allows the vertical louver grills I/O: Power On/Off. to oscillate back and forth automatically(70 Swing). MODE: Selects the appropriate operating mode. CLOCK: Allows you to initiate and/or change the Cool-Heat-Dry (Dehumidifier) -Fan TIME OF DAY setting.
Setting TIME OF DAY (Clock) Instructions: 1) Push and hold the CLOCK key pad for three(3) MODE 12:00 seconds. The clock display will flash indicating TIMER "12.00" for approximately 10 seconds. SWING CLOCK Fig.8. 2) Push either the key pad, to enter the correct time of day.
Page 10
Air Conditioner Operating Instructions (cont'd) 5) Press the key to select the desired fan speed setting (High-Med-Low). See Fig.14. MODE 12:00 TIMER Your selection will be displayed in the MODE COOL FAN SPEED HIGH window (each depression of the fan key will TIMER TEMP.
Page 11
DRY (Dehumidifier ) Operating Instructions 1) Press the ( on/off) key pad to switch on the unit. 2) Press the MODE key until the word MODE 12:00 TIMER (Dehumidifying) is displayed in the display Water Full MODE FAN SPEED HIGH window.
Page 12
DRY( Dehumidifier) Operating Instructions (cont'd) 6) To connect the continuous drain option. Remove the water tank from the cabinet. Inside the cabinet (water tank area) you will find a section of hose hanging beside the water tank, which is plugged/capped at the end.
Heater Operating Instructions(For Heating/Cooling Models Only) 1) Press the MODE key until the word Heat is displayed in the window. Fig.20. Each MODE depression of the MODE key will advance to a 12:00 TIMER Water Full MODE HEAT different mode setting (Cool-Heat-Dry Fan).
Page 14
Fan Operating Instructions 1) Press the (on/off) key pad to switch on the unit. MODE 2) Press the MODE key until the word Water Full MODE displayed in the window. Fig. 25. Each FAN SPEED HIGH TIMER depression of the MODE key will advance to a Cool/Heat/Dry...
Auto-Timer Instructions NOTE: TINE OF DAY CLOCK must be set before the AUTO-TIMER feature will operate The AUTO-TIMER feature offers a unique selection of multiple choice, fully automatic on/off(start/stop) programs between 0-23 hrs, 50 min. Under any one mode of your Portable 4 Season Home Comfort unit. The programs are as follows: Auto-off: Pre-select a time that will turn off the...
Setting the AUTO-ON TIMER(cont'd) 5) All of the settings are now registered. TURN THE UNIT"OFF" USING THE I/O SWITCH. 6) To set the AUTO-ON timer, the unit must be turned to the "off" position (non-operational). 7) Press the TIMER-ON key pad to initiate the AUTO-ON time sequence.
Page 17
Setting the AUTO-OFF TIMER Beffor setting the AUTO-OFF timer, the time of day clock must be set/operational. 1) To set the AUTO-OFF timer, the unit must be turned on (I/O switch) and operational. 2) Press the TIMER-OFF key pad to initiate the AUTO-OFF time sequence.
Page 18
Setting the AUTO-ON & AUTO-OFF TIMER IMPORTANT: The desired AUTO-ON & AUTO- Before setting the AUTO-ON & AUTO-OFF Timer, OFF time must be registered within a 5 second time of day clock must be set/operational. You period (after pressing the TIMER-ON/OFF key must also select the appropriate operating MODE pads) otherwise the selected time will not...
Care and Maintenance CAUTION Before cleaning or servicing this unit, it is recommended that the unit be disconnected from any electrical supply outlet Do Not use gasoline, benzene, thinner or any other chemicals to clean this unit, as these substances may cause damage to the finish and deformation of plastic parts.
Need help?
Do you have a question about the MPA-08CR and is the answer not in the manual?
Questions and answers