Creo Defaults - Diamond Creo User Manual

When the Creo is set to Trigger operating mode, the scanner will turn on when it receives a button press
or a serial activate command is programmatically sent to the reader. The serial trigger activate and
deactivate commands utilize the following format.
When the Creo receives the Trigger Activate command its' LED illumination will come on and it will begin
looking for barcodes. The scanner will turn off and deactivate the scanning phase when either the
scanner finds and decodes a valid barcode, the scanner receives the trigger deactivate command, or the
scanners serial time out value has been reached (see Read-Time Out in the below command list, default
value is 30 seconds).

Creo Defaults

The scanner can be restored to its factory default setting by either scanning barcodes or
programmatically sending commands to the reader. The programmatic codes are listed in the
List table in this guide.
To restore the device to custom defaults by scanning barcodes, scan the Activate Custom Defaults
barcode below. To restore the scanner to factory defaults first scan the Remove Custom Defaults barcode
below and then scan the Activate Defaults barcode.
Activate Custom Defaults
You have the ability to save a set of commands as a custom configuration. This can be done
programmatically using the MNUCDP command as listed in the below tables or by scanning the below
MNUCDP Barcode. The sequence to do this is to first programmatically send or scan the MNUCDP
command, then send the commands that you wish to include in your custom configuration, then send or
scan the below MNUCDS command (Save Custom Defaults).
If you made a mistake or wish to change the value of one of the commands in your sequence of custom
commands simply send or scan the MNUCDP. Then send or scan the code for the setting you wish to
change and then rescan or resend the MNUCDS command and the custom defaults in the Creo scanner
will be updated.
Trigger Activate:
Trigger Deactivate:
Creo Compact Hand Held Scanner User Guide v 1.3
P a g e
SYN T CR
SYN U CR
| 14
Command
Remove Custom Defaults