Commissioning & Battery Charging; Wearing The Bubble - CENTROPIX BUBBLE2 User Manual

Commissioning & Battery Charging
BUBBLE
Charging is required before using the
BUBBLE
the first time. The battery of the 2 is charged
inductively with the supplied charging station. To
do this, plug the USB-C connector into the char-
ging station and the USB connector into a suitable
USB socket of a power plug or to a device with
a supply current (e.g. computer). As soon as the
charging function is ready, a green LED in the char-
ging station lights up.
BUBBLE
Now place the 2 on the inductive charging
station. As soon as the charging function starts, the
BUBBLE
top LED on the back of the 2 lights up in
blue. If the blue LED flashes or is off, the battery is
fully charged. The full charging time is 3-4 hours.
BUBBLE
Now the 2 is charged and switched on.
BUBBLE
The 2 is supplied with a frequency of
7.83 Hz and an intensity level of 40 µT. With this
B
setting, the 2 can also be used without an app.
07
Correct communication channel
BUBBLE
2 for Important: The 2 CANNOT connect directly
to the internet (WiFi) or the CENTROPIX app (Blue-
B
tooth). Communication with the 2
exclusively by means of infrared via the supplied
charger! The correct communication path to the
is therefore as follows:
1 2
CHARGER &
SMARTPHONE BUBBLE 2 CENTROPIX APP
Connect the
Connect your cell Open the
phone to the charger to a power CENTROPIX app
Internet using source. on your cell phone.
WiFi or mobile
B
2
Place the on Connect the
data.
the charger. with the app.
Activate Bluetooth.
The data transfer Select the desired
takes place frequency program.
automatically
via infrared.

Wearing the BUBBLE

BUBBLE
The
supplied leather collar or with one of the three
takes place necklaces around the neck. It is of course possible
to replace the supplied leather collar or necklaces
B
2 with another necklace. Make sure that the light
signal points towards the body. The
be worn directly on the skin or over clothing (e.g.
T-shirt, shirt, blouse, sweater).
3
Please be careful when pulling the leather collar
over your head to avoid damaging the collar or the
housing eyelet. Please note that damage to the
collar or the housing eyelet is not covered by the
warranty (liability for material defects).
There are two ways you can wear the
1st variant:
Attach the supplied carabiner
B
2
through the eyelet on the housing
and then thread the collar through
the carabiner.
2
2nd variant
2 is worn around the neck with the
Alternatively, you can wear the
carabiner. To do this, take the collar, form a loop
and pass it through the housing eyelet from behind.
Then thread the two ends of the collar through the
BUBBLE
2 can
loop and close the collar to secure it.
BUBBLE
2
:
• The BUBBLE
not be worn.
• The BUBBLE
• The BUBBLE
near the solar plexus.
• During the charging process, the B
facing upwards.
BUBBLE
2 without a
Important notes
2 must be taken off at night and must
DE
2 logo must face forwards when worn.
EN
2 should be worn below the sternum
2 logo must be
08