Airthereal PA300-GO - OZONE GENERATOR Manual

Table of Contents

Contents

1 IMPORTANT SAFEGUARDS
2 SPECIFICATIONS
3 PARTS
4 HOW TO USE
- 4.1 FIRST
- 4.2 TURN ON/OFF
5 OZONE SETTING
6 TIMER SETTING
7 BATTERY
8 Documents / Resources
- 8.1 Download manual

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.

Use in unoccupied spaces only!
People, pets, and animals should not stay in the room for more than 1 minute during the ozone treatment. It's okay to start the unit and then leave the room a few seconds later
There might be an ozone smell remaining in the room after treatment. Some people describe it as a faint smell of chlorine, like you'd notice at the swimming pool or hot tub.
Open doors and windows to ventilate the space for at least I hour after treatment ends before occupying the space

MECHANISM
Ozone - Powerful sterilizer and deodorant.
Ozone generators create O3 using mechanisms such as an ultraviolet light or a corona discharge (a type of electrical discharge) Ozone (O3) contains three atoms of oxygen. The third oxygen atom makes ozone extremely reactive, which readily attaches itself to other molecules. When odors, bacteria or viruses meet ozone, oxidation reactions occur and both parties are destroyed. Ozone essentially reverts back to oxygen. That's why it's environmentally friendly.

SPECIFICATIONS

Model Number	PA300-GO	Operating Temp	14-1400F (-10-600c)
Power Supply	DC 5V	Unit Dimensions	2.9 x 2.9 x 4.8 inch
Rated Power	4W	Unit Dimensions	(73 x73 x 120 mm)
Battery Capacity	5000mAh	Unit Weight	0.73 Lbs (0.33 kg)
Noise Level	s45dB

PARTS

Do not operate the unit unless it is completely assembled.

There are no user-serviceable parts inside the unit.

HOW TO USE

FIRST

When starting to use, turn the battery switch to the right, the machine enters standby mode, and the indicator light will turn red. The battery switch must be turned off after use.

If you do not turn off the battery switch after use and leave it for a long time, the battery will be scrapped and cannot work.

HOW TO USE

TURN ON/OFF

Long press for 3 seconds, the switch indicator will turn white, the unit will begin to work. Long press for 3 seconds, it stops and enters the standby mode

information Note:

Low mode is the default setting
The PA300-GO operates in a 5/15 min cycle. This means it runs for 5 minutes then enters standby for 15 minutes, which enables ozone decomposition and ensures appropriate ozone levels for food disinfection

OZONE SETTING

Press to choose the ozone level:
OZONE SETTING

TIMER SETTING

Press to set the timer:
TIMER SETTING
Once you turn on the ozone machine, it will enter the HOLD mode (there will be no time setting indicator light) which runs continuously until the battery dies

BATTERY

Please fully charge the machine before first use, which usually takes 2 to 3 hours. If your unit cannot be powered on after 3 hours charged, please contact support@airthereal.com.

Please use USB to charge the PA300-GO
The battery indicator light green means the unit has full charge
When the unit is low battery, the indicator light will tum red and flashes for 15s, shuts down at the end, you need to be charged soon