XCITE XCEBM3ST Installation & Operating Instructions page 2

INSTALLATION & OPERATING INSTRUCTIONS
Product Name: EXIT BOX - SELF TEST
1
Remove product from all packaging.
3
Remove cap from desired cable entry point.
5
Terminate the supply cable according to the markings on the terminal block.
7
Ensure battery pack is connected.
Page 2 of 2
Tamlite Technical
Stafford Park 12,
Telford, Shropshire,
TF3 3BJ
+44(0)1952 292441
technical@tamlite.co.uk
Document No: V2
2
Remove end cap and slide out legend.
4
Bring in mains supply cable and use appropriate fixings to secure the luminaire
body to the mounting surface.
6
To disable self test unplug the connector, marked by a box and "disable" written
underneath, remove the green plug completely exposing the pins.
8
Replace legend panel and end cap.
Functional test = A 30 second discharge test automatically performed every 30 days.
The timing of this test is set randomly during commissioning of the luminaire.
Duration test = A full duration test automatically performed annually to check the battery capacity.
Permanent green
Flashing green
Double red flash
(Twice every three seconds)
Triple red flash
(Three times every three seconds)
*For illustration purposes only
Normal operation
Performing functional or duration test
Light source failure
Battery or charging failure