EPH Controls GW04 Instructions Manual page 9

Pairing the RF1B Receiver to
Note:
When installing a CP4
have a pre-established RF connection.
Note:
When installing a CP4i
established RF connections so there is no need to carry out the steps in this section.
The RF1B needs to have to the HUB light illuminated to pair to a GW04.
If the HUB light is active, please skip to step 1. If the HUB light is not
illuminated, please follow 'Making a HUB receiver' instructions below.
Making the RF1B a HUB receiver:
Hold &
Manual
The HUB light will illuminate. The receiver is now a HUB.
The RF1B is now ready to pair to the GW04.
1. On the RF1B receiver:
Hold on the RF1B until RF LED flashes.
Connect
2. On the GW04 Gateway:
Hold the RF Connect button
The Gateway & receiver will stop flashing. Paring is now complete.
The white RF light on the Gateway will stay illuminated.
Note:
When connecting multiple receivers to a gateway, ensure that all branch
receivers are connected to the hub receiver. There can only be 1 hub receiver in
a system. Allow 5 minutes for all receivers to synchronise with the hub receiver
before connecting the gateway to the EMBER App. See page 51 & 52 of the CP4
instructions.
Note: Mount the receivers approx 25cm apart to prevent interference.
the GW04 Gateway
or CP4-HW
V2
, the thermostat, receiver and gateway will have pre-
V2
for 5 seconds.
Connect
until RF LED flashes.
, the thermostat and the receiver will
V2
V2
9