Setting The Unit And Pressure; Switching The Product On/Off; Removing The Adapter From The Product - Parkside PMK 150 A1 Operation And Safety Notes

2 . Connect the mains plug
socket .
DC Connection
1 . Remove the 12 V plug with cord
the storage compartment for 12 V plug with
[ 11 ]
cord .
2 . Connect the 12 V plug
cigarette lighter socket .
˜ Setting the unit and pressure
NOTE
u
The pressure can be displayed in units of
bar, PSI or kPa:
– bar: 100 Kilopascal
– PSI: Pounds per square inch
– kPa: Kilopascal
u
The pressure value can be changed in
0 .05 increments .
u
The objects you plan to use with the
product must be compatible with the air
pressure and flow rate of the product .
Using objects that require higher pressure
or flow than the product can deliver may
result in poor performance or damage to
the objects .
u
Recommended tyre pressure: Observe
the information supplied by the
tyre manufacturer and the vehicle
manufacturer . Do not exceed the
maximum pressure rating .
u
This product is not calibrated! For a
calibrated measurement value, check the
actual tyre pressure using a calibrated
meter after you have inflated the tyres
yourself, e .g . at a petrol station .
1 . Set the desired unit: Press the BAR/PSI/
[ 5 ]
kPA button .
2 . Set the desired pressure:
– Press the + button
value .
32 GB/IE
16 ] [
to the mains
12 ] [
from
12 ] [
to a 12 V
6 ] [
to increase the
– Press the − button
value .
The set pressure value is shown on the
[ 3 ]
display .
After a few seconds 0.00 is shown on the
display .
˜ Switching the product on/off
Switching on
Move the on/off switch
o
3 ] [
The display shows the current pressure
value .
The product pumps until the set pressure is
reached .
Switching off
Move the on/off switch
o
The product stops pumping .
3 ] [
The display shows the current pressure
value .
NOTE
u
When you remove the compressed air
13 ] [
hose from the object, the display
shows 0.00 .
˜ Removing the adapter from
the product
NOTE
u
Air may escape from the valve of the
inflatable object when removing the
compressed air hose
the compressed air hose too quickly .
1 . Fold up the clamping lever on the
compressed air hose
2 . Remove the compressed air hose
7 ] [ 8 ] [
the adapter /
4 ] [
to decrease the
1 ] [
to position I .
[ 1 ]
to position O .
3 ] [
[ 13 ]
. Do not remove
[ 13 ]
.
13 ] [
with
9 ] [
/ from the object .