Related Manuals for NEFF D66B20N0GB
Summary of Contents for NEFF D66B20N0GB
- Page 1 Installation instructions and how to use and look after your built-in cooker hoods NEFF (UK) Ltd...
- Page 2 Fig. 1 Abb. 1 ELECTRO mind. mind.
-
Page 3: Appliance Description
Light / fan technical measures, such as reciprocal switches interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. -
Page 4: Before Using For The First Time
Use carefully. They contain important hoods accepts no liability for complaints information concerning your personal which can be attributed to the design safety as well as on use and care of the and layout of the pipework. appliance. Please retain the operating and installation instructions for a subsequent owner. -
Page 5: Safety Instructions
Never operate the extractor hood (max. 15 minutes) at maximum thermal without a grease filter. load, otherwise there is a risk of burns if the housing surfaces are touched or a risk of Overheated fat or oil can easily catch fire. -
Page 6: Operating Procedure
Ventilator settings By cleaning the metal grease filters at appropriate intervals, the possibility of them catching fire as a result of a build-up of heat such as occurs when deep-fat frying or roasting is taking place, is reduced. Cleaning the metal grease filters:... - Page 7 filters down. 2. Insert an activated carbon filter on the At the same time take hold of the under- right and left of the fan motor and rotate side of the grease filters with your other the filters until they lock into position.
-
Page 8: Cleaning And Care
Cleaning and care Replacing the light bulbs Isolate the extractor hood by pulling out 1. Switch off the extractor hood and pull the mains plug or switching off the fuse. out the mains plug or switch off the electricity supply at the fuse box. -
Page 9: Installation Instructions
Exhaust air Recirculating air 13,5 060 cm 12,5 14,0 070 cm 13,0 14,9 090 cm 13,9 15,8 100 cm 14,8 17,5 120 cm 16,0 We reserve the right to construction changes within the context of technical development. - Page 10 flue that is interlocking, etc. currently used for other purposes, nor into a shaft that is used for ventilating rooms in If the air intake is inadequate, there is a which stoves or fireplaces are also located.
- Page 11 flap should be mounted inside the section that equates to that of round extractor hood unless there is already one pipes. fitted in the outlet duct or wall ventilation There should be no sharp bends. box. If no one-way flap was enclosed with the...
-
Page 12: Electrical Connection
A separator must be installed in the household circuit. A suitable separator is a switch that has a contact gap of more than 3 mm and interrupts all poles. Such devices include circuit breakers and contactors. -
Page 13: Installation
5. Screw on the 2 brackets for fixing the Operating Instructions). upper and lower flue ducts. 2. Draw a line on the wall from the ceiling 6. In order to help fix the hood onto the to the lower edge of the hood at the... - Page 14 Installation 08. Insert the other 4 screws with washers. 12. Screw the upper flue duct to the sides of the fixing bracket with 2 short Before the 4 screws are tightened screws. down, align the extractor hood properly. 13. Position the lower flue duct on the extractor hood and screw the extractor hood to the flue duct from below with...
- Page 15 Z5115X5 353121...
- Page 16 NEFF (UK) Ltd. Grand Union House, Old Wolverton Road, Old Wolverton Milton Keynes, MK12 5PT Tel: 01908 328300 9000 432 197 Fax: 01908 328399 Printed in Germany 0209 Es.
Need help?
Do you have a question about the D66B20N0GB and is the answer not in the manual?
Questions and answers