Vega VEGABAR 29 Operating Instructions Manual page 19

ISO 4400 plug with
hinged cover
VEGABAR 29 • Three-wire: transistor, 4 ... 20 mA (active)
Fig. 12: Loosen the plug insert
1 Cable gland
2 Plug insert
3 Plug housing
4. Remove approx. 5 cm of the cable mantle, strip approx. 1 cm
insulation from the individual wires
5. Lead the cable through the cable gland into the plug housing
6. Connect the wire ends to the screw terminals according to the
wiring plan
1
Fig. 13: Connection to the screw terminals
1 Cable gland
2 Plug housing
3 Plug insert
4 Plug seal
7. Snap the plug insert into the plug housing and insert the sensor
seal
8. Plug the plug insert with seal to VEGABAR 29 and tighten the
screw
The electrical connection is finished.
Proceed as follows:
1. Loosen the screw in the cover of the plug connector
2. Open the cover and remove it
3. Press the plug insert downwards
4. Loosen the screws of the strain relief and cable entry
5 Connecting to power supply
3
2
2
3
4
1
19