Omron WL Datasheet page 8

Standard Plungers
Type Actuators
Top
Top Plunger
Top-roller Plunger
Top-ball Plunger
Horizontal
Horizontal Plunger
Horizontal-roller
Plunger
Horizontal-ball Plunger
Note: Sealed roller.
Lamp-equipped Models
Operating Rated voltage
characteristics
Neon lamp 125 VAC
250 VAC
LED 10 to 115 VAC/VDC
Note: 1. In the model number, @ indicates the actuator number. For example, CA2, D, NJ, etc.
2. The default setting is "light-ON when not operating." Turn the lamp holder by 180 to change the setting to "light-ON when operating."
Ordering Information
When ordering general-purpose indicator-equipped models insert the specifications number at the end of the basic model number.
E.g.: When a neon lamp is installed in a General-purpose/Standard Roller Lever Switch (WLCA2).
WLCA2
Standard
When ordering indicator-equipped molded terminal models, insert the specifications number at the end of the standard model number.
E.g.: When a Neon Lamp (WL-LE) is installed in a general-purpose molded terminal model (WLCA2-139).
WLCA2-139
Standard
Note: The indicator cover cannot be replaced on the molded terminals. In all cases the indicator does not light when the load is ON.
F-64
Two-circuit Limit Switch
Model
WLD
WLD2
WLD28 (See note.)
WLD3
WLSD
WLSD2
WLSD3
Leakage current
Approx. 0.6 mA
Approx. 1.9 mA
Approx. 0.5 mA
LE
Lamp
specifications
LE 2
Lamp Lamp
specifications wiring
WL
Standard Flexible Rods
Coil spring
Steel wire
Microload Models
A series of microload models has also been developed for the config-
urations outlined on pages 62 to 64. The model numbers become
WL01@. For example, WLCA2 becomes WL01CA2.
Lamp-equipped Switch
WL@-LE (See note 1.)
WL@-LD (See note 1.)
2: NC connection: Light-ON when operating
3: NO connection: Light-ON when not operating
Actuators
Spring dia. 6.5 WLNJ
Spring dia. 4.8 WLNJ-30
Resin rod dia. 8.0 WLNJ-2
1.0-dia. wire WLNJ-S2
Lamp-equipped cover only
WL-LE
WL-LD
Model