Do you have a question about the RAPID SEAR and is the answer not in the manual?
Questions and answers
Summary of Contents for Matador RAPID SEAR
Page 1
Before using the Steak Searer, remove any packaging material within and around the Steak Searer supplied for protection during transit. MATADOR RAPID SEAR Retain manual for future reference.
Page 2
This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with one of the following: An enclosure with walls on all sides, but at least one open side at least 25%...
.Always comply with all applicable domestic and international Directly dangerous situation that may lead to death or safety, health, and working regulations. In their absence all severe injuries. instructions in this manual must be followed, along with AS/NZS 5601 and local gas authority. MATADOR INSTRUCTION MANUAL...
About the Handling of Gas How to Change Gas Bottle Gas is highly flammable and explosive. 1. Cylinder must be replaced in a flame-free atmosphere. Minimize the risk of explosion and fire: 2. Do not smoke while changing the cylinder. .Before connecting new gas bottles, let the device cool 3.
Put a cover on the grill if want to store the grill cracked or leaking. outdoors for a long period. NOTE! Assemble the BBQ grill as shown. Assembly Set up the products on a firm, level, and sufficiently robust surface. MATADOR INSTRUCTION MANUAL...
Page 6
ASSEMBLY INSTRUCTIONS STEP 1 Inserting the battery for the ignition The ignition needs an AA-battery to work(not included). Unscrew the battery holder at the back of the grill, insert the battery and screw it back in.
Page 7
For every operation the heat shield (5) must be drawn out to protect the bench surface in front of the appliance. If this is not done the surface will suffer heat damage and cannot be covered under warranty. STEP 3 MATADOR INSTRUCTION MANUAL...
Page 9
ATTENTION! Please maintain distance Please note that due to security reasons it is extremely important to maintain a distance of at least 27 inch (70cm) between the grill and the gas bottle. MATADOR INSTRUCTION MANUAL...
Page 10
LEAK TEST Before lighting your rapid sear it is important to carry out this simple test to check whether the gas cylinder, hose and regulator are working / connected correctly. NEVER TEST FOR GAS LEAKS USING A LIT MATCH OR OTHER NAKED FLAME...
.Allow the grill to cool down fully before cleaning and storing. down the control knob for 15 seconds to ensure flame safeguard stays open. 5) If burner does not light,turn to off, wait a minute for any gas to disperse and try step 4 to 5 again. MATADOR INSTRUCTION MANUAL...
Connecting gas .NEVER USE AN OPEN FLAME to test for leaks at anytime. supply system .If bubbles form over any of the joints, there is a leak. Turn off the gas supply and retighten that joint. Repeat the test. If Important notes bubbles form again, stop trying;...
Pre-heat for 5-10 min? Clean the burner. Please contact service department directly if you cannot eliminate the error by yourself. Please remember that repairs carried out by non-professionals will invalidate your warranty claim and may cause additional costs. MATADOR INSTRUCTION MANUAL...
Need help?
Do you have a question about the RAPID SEAR and is the answer not in the manual?
Questions and answers