Advertisement
Multi voltage photoelectric sensor in plastic housing with timer function
E3JM
The square sized E3JM family
provides 12 to 240 VDC and 24 to
240 VAC power supply voltage, an
enhanced sensing distance and a
timer function.
• 12 to 240 VDC and 24 to 240 VAC
supply voltage
• Relay or solid state relay output
• Timer function
Ordering Information
Sensor type
Through-beam
Retro-reflective with M.S.R.
Diffuse-reflective
E3JM
Sensing
Connec-
Timer function
distance
tion
method
10 m
Terminal
–
block
ON or OFF delay
(with
0.1 s to 5 s
PG 13.5)
4 m
–
ON or OFF delay
0.1 s to 5 s
700 mm
–
(adjustable)
ON or OFF delay
0.1 s to 5 s
Order code
Relay output
DC SSR output
minus common
E3JM-10M4-G-N
E3JM-10S4-G-N
E3JM-10M4T-G-N E3JM-10S4T-G-N E3JM-10R4T-G-N
E3JM-R4M4-G
E3JM-R4S4-G
E3JM-R4M4T-G
E3JM-R4S4T-G
E3JM-DS70M4-G E3JM-DS70S4-G E3JM-DS70R4-G
E3JM-DS70M4T-G E3JM-DS70S4T-G E3JM-DS70R4T-G
plus common
E3JM-10R4-G-N
E3JM-R4R4-G
E3JM-R4R4T-G
1
Advertisement
Table of Contents
Related Manuals for Omron E3JM
Summary of Contents for Omron E3JM
-
Page 1: Ordering Information
Multi voltage photoelectric sensor in plastic housing with timer function E3JM The square sized E3JM family provides 12 to 240 VDC and 24 to 240 VAC power supply voltage, an enhanced sensing distance and a timer function. • 12 to 240 VDC and 24 to 240 VAC supply voltage •... - Page 2 2 m (200 mm) (See note 2.) E39-RS3 Note 1. For the complete overview of available reflectors please refer to www.industrial.omron.eu or to the accessory datasheet E26E. 2. Values in brackets are the minimum required distance between the Sensor and Reflector.
-
Page 3: Specifications
2,000 VAC, 50/60 Hz for 1 min. between current-carrying parts and case Vibration resis- Destruction 10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions tance Malfunction 10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions... -
Page 4: Engineering Data
Black carbon SUS (Luster) Aluminum foil (No luster on the back) Operating level 16 18 80 100 120 140 160 180 200 220 1000 1200 Distance (m) Distance X (mm) Side length of sensing object (mm) Excess Gain Ratio vs. Set Distance Excess Gain Ratio vs. -
Page 5: Operation
Operation Output Circuit Relay Output Models DC SSR Output Models E3JM-@M4(T) E3JM-@S4(T) 24 to 240 VAC 24 to 240 VAC 12 to 240 VDC 12 to 240 VDC Power source Photoelectric Power Polarity: source Sensor Optional Polarity: Optional Main circuit... -
Page 6: Precautions For Correct Use
! Warning Through-beam Models For a E3JM with the timer function, the indicator will be lit when This product is not designed or rated for ensuring safety of persons. incident light is received while the mode is switched to Light-ON, Do not use it for such purposes. - Page 7 Receiver side). Adjust the four wires to the same length when the Ta output is to be used only. If both the Ta and Tb outputs are to be used, treat Terminal protection cover them as shown in the following diagram.
- Page 8 • Places where the E3JM is directly exposed to water, oil, or chemicals. Dimensions Note 1. The operating mode switch and timer mode switch are located inside the cover. 2. All units are in millimeters unless otherwise indicated. E3JM-10@4T E3JM-DS70@4(T) E3JM-R4@4(T) 24.5...
- Page 9 Reflectors Seal-type Long Slit E39-R1 (Provided with Retro-reflective Models) E39-S39 40.3 Materials: Reflective side: PMMA (Acrylic resin) Two, 3.5 dia. Back side: ABS resin 1± 20 26.5 Materials: Polyester 0.1-mm thick 59.9 Small Reflector (Order Separately) E39-R3 Materials: Reflective side: PMMA (Acrylic resin)
- Page 10 This is not intended to be an exhaustive list OMRON shall not be responsible for the user’s programming of a pro- of all possible uses of the products, nor is it intended to imply that the grammable product, or any consequence thereof.
Need help?
Do you have a question about the E3JM and is the answer not in the manual?
Questions and answers