Preparing For Use - Parkside PSBS 24 A1 CORDLESS HAMMER DRILL Operation And Safety Notes

The green charge indicator LED
the charging process is complete and the
battery pack 9 is ready for use.
½
Do not use the quick-charge process to charge
a battery pack for a second time in close
9
succession. Otherwise there is the danger that
the battery pack
9
and its useful life and that of the charger reduced.
½
Switch the charger
utes between successive charging processes.
To do this pull the mains plug out of the socket.
©
In order to remove the rechargeable battery,
turn the appliance 180°.
Press the unlocking button
chargeable battery pack
Push the rechargeable battery pack
the appliance.
©
Press the battery charge state test button
The remaining charge capacity is shown on the
LED display .
2
©
the device achieves a speed of approx. 500 min
and a high torque. For example, for screwing work
with small screw diameters.
the device achieves a speed of approx. 1800 min
and a lower torque. For example, for rapid drill
progress in masonry or large drill or screw diameters.
shows that
16
will become overcharged
off for at least 15 min-
14
and push the re-
8
out of the appliance.
9
9 onto
3
1
1
©
Use the torque preselection ring
When this set torque is reached the clutch decouples
the drive. This allows you to screw in screws to a
predetermined depth, which is ideal e.g. for screw-
ing in a series of screws.
Select a lower setting for small screws or soft
materials.
Select a high setting for large screws, hard ma-
terials, or when screwing out screws.
For drilling tasks select drilling setting by placing
the torque preselection ring in the
©
Turn the setting ring
Turn the setting ring
©
Your cordless hammer drill has a fully automatic spindle
lock and is fitted with a single-sleeve drill chuck
. with radial lock "Made in Germany" by
Once the motor has come to a halt, the drive shaft
is automatically locked so that the quick-action drill
chuck 11 can be opened simply by turning it in the
direction of the arrow (see labelling at the front of
the drill chuck "
After you have inserted the tool you wish to have, turn
-1 the drill chuck in the direction of the arrow until you
cannot hear any click any more (see the labelling on
the front of the drill chuck "
drill chuck will then lock automatically. The spindle
lock releases itself automatically when the motor is
started (by operation of ON / OFF switch
-1

Preparing for use

13 to set the torque.
position.
to the symbol .
12
12 to the symbol .
AUF / OPEN").
ZU / CLOSE"). The
6
GB/IE/CY
.
).
11