Firmware Upgrade - AlienTek T80 User Manual

Rotate the display by 180 degrees, and
the functions of buttons A and B are
10.Rota 180
reversed. Suitable for left-hand work
mode
Turn on and off heat immediately after
11. Po_heat
power-on
Fine tune the error between the actual
12.Temp Trim temperature
temperature
Restore the parameters to the factory
13.Restore
state
14.Ver Info Show version
Note:
① Temperature trim method: in working condition, set the target temperature to
350℃, use the soldering iron thermometer to measure the actual temperature after
the temperature is stable, record the error between the target temperature and the
actual temperature (the value can be positive or negative), and then enter the menu
Fill in the error in temp trim value.
② The step of sleep temperature adjustment is fixed at 10℃

10. Firmware upgrade

Step 1: Scan the QR code below to download the latest firmware (e.g T80_APP. atk).
Step 2: Power off the device, press and hold the B button, then use the USB Type-c cable to
connect to the computer, power on the device, about 4 seconds, the screen displays "Upgrade...",
then release the button. The operation is shown in Figure 10-1 below:
Step 3: Open the upgrade software, wait for the device to automatically connect, or click
to re-connect. The connection is successful as shown in Figure 10-2 below:
User Manual
T80&T80P Smart Soldering Iron User Manual
and the displayed
Download
Figure 10-1 Connection
8
Pocket size soldering iron

Rota 0
Rota 0

Rota 180

Turn on
Turn off

Turn off
-50~50 ℃
0
www.alientek.com