Incorrect use or operation may cause serious injury. PRODUCT INTRODUCTION The Aussie Traveller Wall Mounted Washing Machine is a great space-saver to provide the convienience of your own washing machine in your caravan or RV. Featuring intelligent frequency conversion, high temperature cleaning, drainage protection during winter and a maximum load of 2.5kg.
IMPORTANT SAFEGUARDS 1. Please use a 3-PIN power socket with good grounding, 230V ~ and above 10A. Do not use an extension cord. 2. Please use the plug to plug and unplug the power cord. Do not pull on cord to unplug. Do not use damaged power cord.
PARTS DESCRIPTION When installing on a wall, refer to the installation guide supplied with purchase. If installation guide is not available, please contact your seller prior to attempting installation. INSTALLATION Connector assembly CONNECTION BETWEEN WATER INLET TEE JOINT AND FAUCET: 1.
Page 5
INSTALLATION (cont.) 4. Press the connector against the faucet port to make its internal gasket fully contact with the faucet (please note that the gasket cannot be fully taken out). Please select standard faucet. The faucet mouth must be flat. If it is uneven, please flatten it.
ATTENTIONS BEFORE USE 1. WASHING GUIDE IDENTIFICATION Check the washing guide logo on the laundry, the fabric with laundry on the logo and its suitable washing method. 2. WASHING In order to get the best washing results, wash only the same kind of cloths in the same washing cycle. For different clothes, the required water temperature, speed and washing procedures are also different.
BEFORE WASHING INSTRUCTIONS CAUTION Before you use this machine, please make sure that the machine has been properly installed according to the installation instructions. For the first time, it is recommended that you complete a ‘tub cleaning’ or other high-temperature washing procedure without clothes.
BEFORE WASHING INSTRUCTIONS (cont.) 3. LAUNDRY PROCEDURE INTRODUCTION 1. During operation of some programs, the actual display time may change due to the weight of clothes, which is not a washing machine fault. 2. The time required will change when the water pressure, drainage conditions, type of cloths, clothing weight and water temperature change.
CONTROL PANEL (cont.) 4. RINSE BUTTON (including Child Lock) In order to prevent children from operating or opening the door, this button can set the child lock function. After setting the child lock function, other butttons do not work except for the power button. After the program is started, press and hold the ‘RINSE’...
Page 10
MAINTENANCE (cont.) CLEANING THE BARREL After the washing machine has been used for a period of time, there may be dirt in the washing machine cylinder. The purpose of cleaning the inner and outer barrel can be achieved by using the tub cleaning program. NOTE: Do not put clothes and detergents into the barrel in the tub cleaning mode.
TROUBLESHOOTING GUIDE PROBLEM CAUSE SOLUTION 1. Press the 'POWER' button or the 1. Press the 'POWER' button or the 'START/PAUSE' button. 'START/PAUSE' button. Cannot Start 2. Is the power cord unplugged? 2. Connect the power cord plug. 3. Is there a power failure? 3.
NAME AND CONTENT OF PRODUCTS HAZARDOUS SUBSTANCE HAZARDOUS SUBSTANCES PART NAME PBDE Door lock Computer board Power cord Bolt & nuts Water level sensor Draining valve Motor Belt & belt pulley Door assembly Top cover assembly Control panel assembly Housing assembly Inner barrel Base Detergent box...
When tested in accordance with AS/NZS 2040.2 Actual energy use and running costs will depend on how you use the appliance. Cold washing preformance has not been measured and is not guaranteed. MOBROV Model 3000-0301AU For more information, refer to www.energyrating.gov.au Using the Mix program 1300 663 868 | enquiries@aussietraveller.com.au | aussietraveller.com.au...
Product to the wholesale purchaser. 3. If the Product is purchased directly from Aussie Traveller for use by final retail customer and not to be on sold in any way, the Warranty will commence at the time of the original purchase.
Page 15
Product, the final retail customer must pay Aussie Traveller’s usual costs of service work and testing. The final retail customer must bear the cost of the transport of the Product to and from Aussie Traveller or the authorised repair agent, and all insurance of the Product.
Need help?
Do you have a question about the 3000-0301AU and is the answer not in the manual?
Questions and answers