Rate-Limit - HP aruba 8320 Series Service Manual

Removing a threshold from queue 5 in profile mythreshold:
switch(config)# qos threshold-profile mythreshold
switch(config-threshold)# no queue 5
Command History
Release
10.08
Command Information
Platforms Command context
8325
config-threshold
10000

rate-limit

rate-limit {broadcast | multicast | unknown-unicast} <RATE> pps
no rate-limit {broadcast | multicast | unknown-unicast}
Description
Sets the amount of traffic of a specific type that can ingress on an Ethernet port, or on each port of a LAG
interface. Rate limits are enforced separately on each individual member of a LAG, not on the LAG as a
whole.
The form of this command removes the traffic limit for the specified traffic type.
no
Parameter
{broadcast | multicast | unknown-unicast}
rate
Examples
Limiting
multicast
AOS-CX 10.09 Quality of Service Guide | (8320, 8325, 10000 Switch Series)
traffic to on interface
4000 pps
Modification
Command introduced
Authority
Administrators or local user group members with execution rights
for this command.
Description
Specifies the type of ingress traffic to which the rate limit
applies: broadcast, multicast, or unknown-unicast.
The multicast rate limit affects multicast and broadcast
traffic. The broadcast rate limit only affects broadcast
traffic. When both types are applied to the same interface,
broadcast packets are limited to the lower of the two rate
values. Layer 2 BPDU packets, like spanning tree, are also
included in the multicast rate limit.
Specifies the rate limit in packets per second (pps). Range:
64 to 209090910 pps. The actual rate limit varies with
steps approximately equal to the minimum value. Verify
the actual rate limit using the command show interface
<INTERFACE-NAME>.
:
1/3/3
45