Assa Abloy Yale 4700 Series Installation Instructions page 2

5. Remove Inside Knob
Use nail end of
A
wrench provided to
depress inside
knob catch in hole
of inside sleeve
collar and slide
knob off spindle.
B
Please use the wrench to loosen
inside rose nut, then unscrew by hand.
8. Install Inside Rose
Insert inside rose and reinforcing plate
into hole. Turn the reinforcing plate
clockwise until the plate engaged with the
hole, make sure the two rose grooves
face to door hole, then use tool tighten
inside rose securely.
Tool
Reinforcing Plate
11. IN ORDER TO ADJUST THE INCORRECT STATE OF THE KEY HOLE FACING UPWARD, THE KNOB MUST
BE PULLED OUT AND INSTALLED AGAIN. THE METHOD OF INSTALLATION IS DESCRIBED AS BELOW.
A With the other hand,
turn the key counter
clockwise within the
limit of 30° ~90°
C Install again
according to the
correct direction.
(See Step 10)
2"
2"
(51)
1"
1"
Yale® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company. Other products' brand names may be trademarks or registered trademarks of their
respective owners and are mentioned for reference purposes only. These materials are protected under U.S. copyright laws. All contents current at time of publication.
Yale Security Inc. reserves the right to change availability of any item in this catalog, its design, construction, and/or its materials.
All rights reserved. Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
An ASSA ABLOY Group brand
6. Adjust Outside Rose
Adjust lock to fit door thickness by
rotating outside rose nut.
Note: Lock must be centered on door to
ensure latch bolt moves freely.
9. Replace Knob
Important:
Align lug on knob with narrow slot on
side of spindle and push knob all the way
in until knob catch clicks into slot on
knob. Otherwise knob will jam on shaft.
Inside Rose
1-3/4" 1-3/8"
(45) (35)
2"
Product Support Tel 800.438.1951 • www.yalelocks.com
Yale Locks & Hardware is a division of Yale Security Inc., an ASSA ABLOY Group company.
Copyright © 2009, 2012, Yale Security Inc., an ASSA ABLOY Group company.
Door
Centerline
Slot
Lug
B Using the nail end of the
tool provided (or a small
nail), press the knob catch
and pull the knob off.
FOR BEVELED DOORS PLACE
ON HIGH EDGE i.e.
HIGH EDGE
3" 4"
7. Install Lock
Latch unit must be in place before
installing lock. Be sure lock housing
engages with latch prongs and retractor
interlocks with latch tail.
A B
B. Install 2 through bolt screws.
10. Correct Key Hole Position
Upon installation of the lock, it may
happen that key hole faces upward or
downward as shown in the following
drawing. It is advisable to correct all key
holes to be facing downward.
Downward
Correct
TEST THE OPERATION OF THE LOCKSET
Cycle the lock in both the locked and unlocked positions.
STOP
If lock functions smoothly when door is open, but binds
when closed, check door and frame alignment.
DO NOT SCALE
5"
80-9510-0060-000 (08-12)
Upward
Incorrect
2