Changing The Front Axle Case Oil; Replacing The Fuel Filter; Every 800 Hours; Adjusting The Engine Valve Clearance - Kubota RTV-X Operator's Manual

PERIODIC SERVICE
4. Remove the magnet plug (2) and clean off metal
shavings.
(1) Drain plug
(2) Magnet plug
5. After draining, reinstall the drain plug.
6. Fill with the new prescribed oil up to the upper cross
hatched area on the dipstick.
(See LUBRICANTS, FUEL AND COOLANT on
page 65.)
(1) Oil inlet
(2) Dipstick
7. After running the engine for a few minutes, stop the
engine and check the oil level again; add oil to
prescribed level.
Oil capacity
8. Properly dispose of the used oil.
IMPORTANT :
• Do not operate the vehicle immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent
transmission.

3. Changing the front axle case oil

1. Park the vehicle on a level surface.
2. Turn over the rubber sheet.
94
(A) Oil level is acceptable within
this range.
7.0 L (1.8 U.S.gals.)
damage to the
3. To drain the used oil, remove the drain plug and the
filling plug at the front axle case and drain the oil
completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new prescribed oil up to the upper line
on the dipstick.
(See LUBRICANTS, FUEL AND COOLANT on
page 65.)
Oil capacity
(1) Drain plug
(2) Filling plug with dipstick
6. After filling, reinstall the filling plug.
7. Properly dispose of the used oil.

4. Replacing the fuel filter

Contact your local Kubota dealer for this service.

EVERY 800 HOURS

1. Adjusting the engine valve
clearance
Contact your local Kubota dealer for this service.
EVERY 400 HOURS
0.6 L (0.6 U.S.qts.)
(A) Oil level is acceptable within
this range.
RTV-X