Shoulder Belt; Restraint Bar - CASE CONSTRUCTION Alpha Series Operator's Manual

Shoulder belt

Pull the seat belt retractable half (1) across the operator
and buckle securely with the buckle half (2).
A shoulder belt (3) is available from your dealer. Some
machine configurations are equipped with a shoulder belt.
NOTE: A California required 3 inch webbing seat belt kit
is available through dealer service parts. This belt may
be necessary in some industrial applications. Check your
local codes.

Restraint bar

The restraint bar can be adjusted for operator comfort.
To adjust the height of the restraint bar (1):
1. Loosen the two lock knobs (2). One on each side
where the restraint rests on the back of the cab.
2. Turn the adjusting stops (3) out to raise the resting
position of the restraint bar and in to lower the position.
3. Adjust the stops (3) so the restraint bar rests on both
of the stops evenly.
4. Tighten the lock knobs (2).
3 - CONTROLS AND INSTRUMENTS
3-7
1
93109349
1
RAPH12SSL0066AA