Flex Mode - UCHIDA AeroCut nano Max Operation Manual

3.4 FLEX MODE

FLEX MODE allows you to enter work with a high degree of freedom, which is not possible
with MANUSET. Use it when card dimensions are irregular.
① Press FLEX MODE.
② Enter the total length of the paper, the position of the cut mark, and the processing
details from 1 to 20. In this example, the cut pattern shown below is entered.
・ If the pitch of 0.0 is input, all the pitches after that one is corrected to 0.0 (no
operation).
・ Pressing SAME PITCH copies the No. 1 pitch and its relevant operation to No. 2 to
③ When data input is completed, Press OK to Home Screen.
No. 20 pitches.
Move to User Program
Selection Screen.
Save Cut pattern as inputted
into User Program memory.
Return to the previous page.
Go to the next page.
Confirm Cut pattern as
inputted.
AeroCut nanoMAX OPERATION MANUAL
22
Feeding direction