Inserting The Module; Laying Data Cables; Switching The Cleaning Machine On - Miele XKM 3200 WL LMD Operating Instructions Manual

en - Fitting and installation
Inserting the mod-
ule
Laying data cables The technology does not support the simultaneous use of WiFi and
WiFi
LAN
Switching the
cleaning machine
on
54
Remove any stickers or protective caps as necessary from the slot

aperture.
Push the module into the module slot. Gently push the module until

it clicks into place.
LAN.
If you wish to use the WiFi connection, the LAN cable must not be
connected to a network or terminal device. The WiFi signal will only be
available if the LAN cable is not plugged in.
We recommend that you roll the LAN cable up and secure it some-

where at the back of the machine. This will stop it from getting in the
way when the cleaning machine is being installed or undergoing
maintenance work.
If you wish to use the LAN cable for data transfer instead of the WiFi
connection, connect the LAN cable to your terminal device. Plugging
in the LAN cable switches off the WiFi signal automatically.
Take care to ensure that the cable is laid correctly; it should not be

kinked or trapped, for example. Keep the cable away from sharp
edges and do not place it under tension.
Only terminal devices (PCs, printers, etc.) which comply with
EN/IEC 62368 should be used.
Connect the cleaning machine to the electricity supply.

The module is supplied with mains voltage by the cleaning machine.
No additional power connection is required.
After around 90 s, the module is ready for operation and the interface
can be configured.