Nmea 2000; Sonar - Lowrance Ghost Series Installation Manual

NMEA 2000

®
To control the trolling motor from a display unit, connect the trolling motor to the NMEA 2000
display unit documentation for further instructions on how to control the trolling motor.
The trolling motor software can be updated from a display unit connected to the network. Refer to the documentation
supplied with your display unit.
B
A Foot pedal NMEA 2000
B NMEA 2000 backbone
®

Sonar

A HDI Nose Cone transducer is pre-installed in the lower unit of the trolling motor. Its cable is accessed at the trolling
motor foot pedal, and requires a mini 9-pin to regular 9-pin adapter (included, D) to fit a 9-pin sonar input on the back of a
compatible display unit.
A 9-pin to 7-pin adapter cable (not included) is required if your display unit has a 7-pin sonar input.
Refer to the documentation for your display unit for instructions on how to use and adjust the sonar display.
C
A Display unit with regular 9-pin transducer connector (sold separately)
B Display unit with regular 7-pin transducer connector (sold separately)
C Foot pedal transducer cable, mini 9-pin male connector (included)
D Mini 9-pin to regular 9-pin adapter (included)
E 9-pin to 7-pin adapter cable (sold separately, 000-13977-001)
A
interface cable, Micro-C connector
®
SONAR
A
A
D
SONAR
B
E
26
backbone. Refer to the
®