Slide the measuring aid forwards.
2.
Fold the measuring aid down and
3.
click it into place.
Push in the detergent drawer.
4.
13.7 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 31
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End .
13.9 Soaking laundry
To soak the laundry, activate the
soaking before the programme start.
Note: Add the detergent for the soak-
ing cycle in compartment I and the
detergent for the main wash in com-
partment II of the detergent drawer.
→ "Detergent drawer", Page 17
Requirements
¡ The laundry is placed in the appli-
ance.
→ "Loading laundry", Page 32
¡ A programme is set.
→ "Setting a programme", Page 31
¡ The display shows all additional
buttons.
→ "Operating logic", Page 18
Press
Pre-Soaking.
1.
→ "Buttons", Page 25
Start the programme.
2.
→ "Starting the programme",
Page 33
After the soaking time, a signal
sounds and
The door lock is released.
Note: If you want to add laundry, fol-
low the instructions on the display.
→ "Display", Page 22
To continue the programme, press
3.
or wait for approx. 15 minutes.
Basic operation en
flashes.
33