AppNeta m70 Connecting Manual

Included in the box
1 x m70 Monitoring Point
4 x WiFi antenna
2 x Ethernet cable
1 x "Connecting the m70" booklet
1 x power cable
1 x power adapter
Port 0
Connect the m70 to your network
These steps explain how to physically connect an m70 Monitoring Point
to your network so that it can communicate with AppNeta. The complete
setup procedure can be found at
ta-start.
❶
Connect to power
Connect the Monitoring Point to surge protected power using the
power cable and power adapter. Secure the power adapter to the
Monitoring Point with the screw lock on the plug. If the power LED
is off, press the power button.
❷ Connect to network
Connect port 0 on the Monitoring Point to a switch on your
network using an Ethernet cable. The network must provide
connectivity to the APM service.
❸
Check heartbeat
After two minutes, review the heartbeat LED .
Status
 heartbeat
Connected
to APM
Unconfigured
Can't connect
to APM
techdocs.broadcom.com/appne-
Actions required
None. Successfully connected!
Configure Monitoring Point. See
techdocs.broadcom.com/appne-
ta-empsetup
Troubleshoot connection. See
techdocs.broadcom.com/appne-
ta-troubleshoot