Summary of Contents for Samsung BESPOKE ME21DG6500MT
Page 1
Installation Instructions Over The Range Microwave Oven BEFORE YOU BEGIN (Read these instructions completely and carefully.) IMPORTANT Save these instructions for local inspector’s use. IMPORTANT Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. •...
Contents General information Step-by-step installation guide Important safety instructions ....3 1. Placement of the mounting plate..8 A. Removing the microwave oven from the Electrical requirements .
General information IMPORTANT SAFETY INSTRUCTIONS This product requires a three-prong grounded outlet. The power cord of this The installer must perform a ground continuity appliance is equipped with a check on the power outlet box before beginning the three-prong (grounding) plug installation to ensure that the outlet box is properly which mates with a standard grounded.
General information HOOD EXHAUST NOTE: Read these next two pages only if you plan to vent your exhaust to the outside. If you plan to recirculate the air back into the room, proceed to page 11. OUTSIDE TOP EXHAUST (EXAMPLE ONLY) The following chart contains an example of one possible ductwork installation.
Page 5
General information Maximum duct length: NOTE: If you need to install ducts, note that the total duct length of 3 ¼" x 10" rectangular or 6" diameter round duct For satisfactory air movement, the total duct length of should not exceed 140 equivalent feet. 3 ¼"...
General information DAMAGE - SHIPMENT/INSTALLATION • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement. • If the unit is damaged by the customer, repair or replacement is the responsibility of the customer. •...
General information TOOLS YOU WILL NEED # 1 and #2 Phillips Pencil Ruler or tape measure and Carpenter square (optional) screwdriver straight edge Tin snips (for cutting Scissors (to cut template, if Electric drill with ", ½" Filler blocks or scrap wood damper, if required) necessary) and ⅝"...
Step-by-step installation guide 1. PLACEMENT OF THE MOUNTING PLATE A. REMOVING THE MICROWAVE OVEN B. FINDING THE WALL STUDS FROM THE CARTON/REMOVING THE MOUNTING PLATE 1. Remove the installation instructions, Exhaust adaptor, filters, glass tray, and the small hardware Wall Studs Wall Studs bag.
Step-by-step installation guide C. DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET Plate position – beneath a flat bottom cabinet. Plate position – beneath a framed recessed cabinet bottom. Draw a vertical line on the wall at the center of the 30" wide space. Tape the Rear Wall Template onto the wall so that the top of the...
Step-by-step installation guide D. ALIGNING THE WALL PLATE Draw a vertical line on the wall to mark the Centerline Hole A Hole A Draw a Vertical Line Centerline center of the cabinet on Wall from Center notches notches of Top Cabinet above.
Step-by-step installation guide 2. VENTILATION TYPES (CHOOSE A, B OR C) This microwave oven is compatible with the following NOTE: This microwave is shipped assembled for Outside three types of ventilation: Top Exhaust (except for non-vented models). An exhaust adaptor is shipped assembled and attached to the filler- A.
Step-by-step installation guide A. OUTSIDE TOP EXHAUST (VERTICAL DUCT) NOTE: You must attach the house duct to the exhaust adaptor after installation is complete. House Duct A1. INSTALLATION PROCEDURE FOR THE EXHAUST ADAPTOR AND PROPER DAMPER OPERATION CHECK Damper Blower Plate Exhaust Adaptor Back of Microwave...
Step-by-step installation guide 3. Remove the screw that holds the blower motor and 7. Close the blower door. Slide blower shield onto the carefully pull out the blower unit. The wires will top of the blower door opening. extend far enough to allow you to adjust the blower unit.
Step-by-step installation guide C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT) C1. ADAPTING THE MICROWAVE BLOWER FOR 5. Rotate the blower unit counterclockwise 180 °. OUTSIDE BACK EXHAUST Before Rotation After Rotation 1. Remove and save screw that holds blower Plate to microwave.
Step-by-step installation guide 3. INSTALLATION INSTALLATION OVERVIEW A. Prepare the Rear Wall (for outside back exhaust/ horizontal duct only) B. Attach the Mounting Plate to the Wall C. Prepare the Cabinet above D. Mount the Microwave Oven E. Connect the Ductwork (for outside top exhaust/vertical duct only) A.
Step-by-step installation guide To use the toggle bolts: D. MOUNT THE MICROWAVE OVEN Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Wings Mounting Mounting Toggle Toggle Plate Plate Bolt Bolt FOR EASIER INSTALLATION AND PERSONAL SAFETY, Wall Wall Bolt End Bolt End WE RECOMMEND THAT TWO PEOPLE INSTALL THIS...
Step-by-step installation guide 6. Install the grease filters. See the Owner’s Manual 1. Lift the microwave, tilt it packed with the microwave for instructions. forward, and hook the slots at the back bottom edge onto the four lower tabs of the mounting plate.
Before You Use Your Microwave 4. BEFORE YOU USE YOUR MICROWAVE 6. Read the Owner’s Manual. 1. Make sure the microwave oven has been installed according to instructions. 7. Keep installation instructions for the local inspector’s use. 2. Remove all packing material from the microwave oven.
Page 19
Notes DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 19 DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 19 2024-02-16 오전 9:30:39 2024-02-16 오전 9:30:39...
Page 20
DE68-04108A-08 DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 20 DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 20 2024-02-16 오전 9:30:39 2024-02-16 오전 9:30:39...
Need help?
Do you have a question about the BESPOKE ME21DG6500MT and is the answer not in the manual?
Questions and answers