Related Manuals for ENGWE-BIKES L20 2.0
Summary of Contents for ENGWE-BIKES L20 2.0
- Page 2 Table of contents Thank you for choosing the ENGWE series of products. In order to familiarize yourself with the use and ensure a safer ride, please read this manual carefully. 1.Before riding, carefully check if all components are in good working order to ensure yoursafety.
- Page 5 2.3.3 Remove the foam wrapped on the handle bars, and then adjust the instrument to the correct position. Arrange the handlebars and use a 5mm hex wrench to rotate clockwise to install two screws. The inslallation sequence is shown in the following figure. Once the screws and handlebars are in the correct position, tighten the screws and apply appropri- ate force, Do not overtighten.
- Page 6 2.3.4 Remove the foam wrapped around the front fender, as showh in the figure below. Align the front fender lug with the front fork installation hole and tighten the screw using a 4mm hex wrench. Align the front fender bracket with the installation hole,as shown in the figure below, and tighten the screw with a 4mm hex wrench.
- Page 7 2.3.9 When installing the pedals, note the markings "R" (right) and "L" (left). The pedal 2.3.11 Installation of headlights and rack Take the rack out of the cardboard box,align it with the four holes of the head tube, and tighten it with a 5mm hexwrench.Remove the marked with "R”...
- Page 8 *When the vehicle display is set to 0, the motor is in a no-output state, and the vehicle can be ridden like a normal bicycle. *When the display is set to 1-5, it represents different speed levels, with 1being the slowest and 5 beingthe fastest,Lower settings will make your battery last longer and make your ride safer.
- Page 9 Custom parameter setting (e.g., wheel diameter, speed limit, battery level, · assistlevel,power-on password,controller currentlimit,etc.) Resetfunction ·...
Need help?
Do you have a question about the L20 2.0 and is the answer not in the manual?
Questions and answers
i cant unlock nt the pront forks on engwe l20 2.0
Dobrý den ne kole engwe L20 mi svítí P8 a pod ním blikají nuly... Když přidržíme napájení skočí to na hlavní obrazovku a hned zpátky na P8.kody 1212 ani 1313 nefungují.predem děkuji za radu
There is no information regarding the instrument panel menu 1-3. what are the menu meanings for each menu
CAN YOU PRESSURE WASH THE Engwe L20 2.0 EBIKE?