Advertisement
3. Operation
3.3. Fan speed setting
3.3.1. For wired remote controller
Press button ⑩ [F4] to go through the fan speed.
* The number of available fan speeds depends on the model.
Auto
Notes:
The actual fan speed will be different from the fan speed displayed
on the LCD when one of the following conditions is met.
While "Standby" or "Defrost" is displayed
●
When the room temperature is higher than the preset temperature
●
during the heating mode
Right after the heating operation (during stand by for switching
●
the operation mode)
During the dry mode
●
4. Timer
■ Timer functions are different by each remote controller.
■ For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.
4.1. For wireless remote controller (option)
ON/OFF
FAN
MODE
VANE
CHECK
LOUVER
TEST RUN
SET
RESET
AAA
5. Emergency Operation for Wireless Remote-controller (option)
HEAT
8
C
D
B
A
TEMP
AUTO STOP
13
AUTO START
h
2
min
CLOCK
AAA
ON/OFF
1
2
COOL
3.3.2. For wireless remote controller
button to select a desired fan speed.
■ Press ④
• Each time you press the button, available options change with the
display 4 on the remote controller, as shown below.
Auto
Notes:
In the following cases, the actual fan speed generated by the unit
●
will differ from the speed shown the remote controller display.
1. While the display is in "STAND BY" or "DEFROST" states.
2. When the temperature of the heat exchanger is low in the
heating mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the
temperature setting.
4. When the unit is in DRY mode.
1) Set the current time
1 Press the CLOCK button using a thin stick and blink the time A .
2 Press the
and
button to set the current time.
h
min
3 Press the CLOCK button using a thin stick.
2) Set the time to start the unit as follows
1 Press the
button.
AUTO START
• Time can be set while the following symbol is blinking.
On time: B START is blinking.
• The start times is displayed at A .
2 Use the
and
buttons to set the desired time.
h
min
3 To cancel the ON timer, press the
3) Set the time to stop the unit as follows
1 Press the
button.
AUTO STOP
• Time can be set while the following symbol is blinking.
Off time: C STOP is blinking.
• The stop times is displayed at D .
2 Use the
and
buttons to set the desired time.
h
min
3 To cancel the OFF timer, press the
4) Changing the set times
Press the
or
to cancel the timer and repeat from 2) or 3).
AUTO START
AUTO STOP
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not
operating)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the
COOL or
HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units,
pushing the
HEAT button toggles the fan on and off.
Pressing the
COOL or
HEAT button selects the following
settings.
Operation mode
Preset temperature
24 °C/75 °F
Fan speed
button.
AUTO START
button.
AUTO STOP
COOL
HEAT
24 °C/75 °F
High
High
Advertisement
