Antenna Connections - Kenwood KR-V6020 Instruction Manual

System connections
Antenna connections
For the U.S.A., Canada and other countries
FM indoor FM outdoor AM outdoor
antenna antenna antenna
75 ohm
300 ohm = Coaxial
Feeder Cable
AM loop antenna
(The shape may vary depending
on the destination area.)
AM antennas
AM loop antenna
Attach the AM loop antenna to the supplied loop antenna stand
and place it one a shelf, etc., or install it on the rack or wall
with screws.
Rotate the AM loop antenna to the right or left for best
»
reception,
Keep the speaker leads
and AC cord away from
the AM loop antenna. ' ay
Vary the direction of
the loop antenna.
Note:
Do not place the AM loop antenna directly on the unit. As this unit
employs computing devices, placing the AM loop antenna on the
unit may result in noise generation. Place the AM loop antenna away
from the unit.
AM outdoor antenna
in steel buildings or at a great distance from the transmitter,
it may be necessary to install an outside long wire antenna.
The end of this wire should be stripped of insulation and con-
nected to the AM terminal. At this time, keep the loop anten-
na connected.
aN
For Europe
FM indoor FM outdoor AM outdoor
antenna antenna antenna
300 ohm Coaxial !
Feeder Cable J
(The shape may vary depending
th on the destination area.) J
@ FM antennas
FM indoor antenna
Connect the T-shaped indoor antenna (supplied) to the 300
ohm FM ANTENNA terminals. Spread the two arms that from
the top of the ''T'' horizontally and hold them against con-
venient wall surfaces. Try several locations for best results with
frequently listened to stations. Tape the antenna in place where
the best compromise is found between listening results and
appearance,
FM outdoor antenna
Be sure to use an outdoor FM antenna to receive good sound
quality FM broadcasts with a minimum of noise. When con-
necting an outdoor antenna to the antenna terminals of this
unit, connect as illustrated.
For Europe
The 75 ohm/300 ohm antenna adaptor is supplied with this
unit. Be sure to connect the coaxial cable to the adaptor as
instructed in the relevant section ''75 ohm coaxial cable con-
nection''.
Note:
An FM outdoor antenna can be connected to the tuner with either
a 75 ohm coaxial cable or a 300 ohm ribbon feeder. For proper con-
nection, carefully read the instruction manual for the FM outdoor
antenna.
® To minimize auto-ignition noise, locate the antenna as
far from heavy traffic as possible.
®@ Keep the feeder or coaxial cable as short as possible.
Do not bundle or roll up excess cable.
@ The antenna should be at least two meters (6.6 feet)
from reinforced concrete walls or metal structures.
FM outdoor antenna setting
8 kR-v6020 (En)