EnGLIsH DRILL DCD800 DRILL/HAMMERDRILL DCD805 Congratulations! The vibration and/or noise emission level given in this information sheet has been measured in accordance with a standardised test You have chosen a D WALT tool. Years of experience, thorough given in EN62841 and may be used to compare one tool with product development and innovation make D WALT one of the another.
EnGLIsH b ) Use personal protective equipment. Always wear eye Denotes risk of fire. protection. Protective equipment such as a dust mask, non-skid safety shoes, hard hat or hearing protection used GENERAL POWER TOOL SAFETY WARNINGS for appropriate conditions will reduce personal injuries. c ) Prevent unintentional starting.
EnGLIsH Safety Instructions When Using Long g ) Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into Drill Bits account the working conditions and the work to be performed. Use of the power tool for operations different Never operate at higher speed than the maximum •...
EnGLIsH Do not use an extension cord unless it is absolutely • Mains Plug Replacement necessary. Use of improper extension cord could result in risk (U.K. & Ireland Only) of fire,electric shock, or electrocution. If a new mains plug needs to be fitted: Do not place any object on top of charger or place •...
EnGLIsH has reached an appropriate temperature, the yellow light will The battery pack is not fully charged out of the carton. Before turn off and the charger will resume the charging procedure. using the battery pack and charger, read the safety instructions below.
EnGLIsH Transportation with the lower Watt hour rating can exempt the pack from certain shipping regulations that are imposed upon the higher WARNING: Fire hazard. Transporting batteries can Watt hour batteries. possibly cause fire if the battery terminals inadvertently For example, the Transport Example of Use and Transport Label Marking come in contact with conductive materials.
EnGLIsH Description (Fig. A) Do not incinerate the battery pack. WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. USE (without transport cap). Example: Wh rating indicates 108 Wh (1 battery with 108 Wh). Trigger switch Forward/reverse control button TRANSPORT (with built‑in transport cap).
Page 12
EnGLIsH Forward/Reverse Control Button (Fig. A) 2. Insert battery pack into the charger as described in the charger section of this manual. A forward/reverse control button 2 determines the direction of Fuel Gauge Battery Packs (Fig. B) the tool and also serves as a lock‑off button. To select forward rotation, release the trigger switch and Some D WALT battery packs include a fuel gauge which consists...
EnGLIsH Spotlight Mode OPERATION The spotlight will run for 20 minutes after the trigger switch is Instructions for Use released. Two minutes before the spotlight will shut off, it will flash twice and then dim. To avoid the spotlight shutting off, WARNING: Always observe the safety instructions and lightly tap the trigger switch.
EnGLIsH 9. With variable speed drills there is no need to centre punch the point to be drilled. Use a slow speed to start the hole and accelerate by squeezing the trigger harder when the Lubrication hole is deep enough to drill without the bit skipping out. Your power tool requires no additional lubrication.