Steps
1. Place the 2.5-inch hard drive into the hard-drive carrier and align the tabs on the carrier with the slots on the hard drive.
2. Snap the hard-drive carrier onto the 2.5-inch hard drive.
3. Flip over the hard-drive assembly.
4. Place the hard-drive assembly on the chassis.
5. Align the tabs on the hard-drive assembly with the slots on the chassis.
6. Slide and hard-drive assembly into place on the chassis.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
hard
drive, if applicable.
40
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.