Configuring Snmp; Enabling/Disabling Snmp; Updating The Mib Product Id; Configuring Snmp V1 And Snmp V2C - Sony MKS-X1115 User Manual

Valid from-until: Valid period of the software update
license
Properties: Properties of the software update license
selected in the list.
You can toggle between showing/hiding properties
using the [ ] button. Set the [
state to display the properties of the selected software
update license on the right.
Installing/uninstalling a software update
license
Installing a software update license
You can select a software update license key file and
install a license.
1
Open the MLS Manager Home > License > Manage
SUL menu (62101.02).
2
Press the [Detect/Refresh] button.
Boxes that are on the same network as MLS Manager
are detected and displayed in the list at the top.
3
Press the [Install SUL] button.
A computer file selection dialog appears.
4
Select a software update license key file to install.
5
Check the message, then press [OK].
When installation is completed, an "The Software
Update License(s) were successfully installed."
message appears.
Uninstalling a software update license
You can select a software update license and uninstall a
license.
1
Open the MLS Manager Home > License > Manage
SUL menu (62101.02).
2
Select a software update license to uninstall.
3
Press the [Uninstall SUL] button.
4
Check the message, then press [OK].
When uninstallation is completed, an "The selected
Software Update License(s) were successfully
uninstalled." message appears.

Configuring SNMP

You can configure SNMP settings.
] button to the on
You can provide information about the boxes and control
panels in an island to an SNMP manager via the SNMP
agent of MLS Manager.

Enabling/Disabling SNMP

1
2
3
4
5

Updating the MIB Product ID

1
2
3
Configuring SNMP v1 and SNMP
v2c
You can configure a community and host when SNMP is
enabled.
492
Open the MLS Manager Home > SNMP > Common
menu (64101.01).
Enable/disable SNMP using the [Enable] button for
[SNMP Mode].
On: Enable SNMP.
Off: Disable SNMP.
When disabled, proceed to step 4.
Set whether to send a trap when authentication fails
using the [Auth Trap] button.
On: Send trap when SNMP authentication fails.
Off: Do not send trap when SNMP authentication
fails.
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then
press [OK].
Check the message, then press [OK].
Open the MLS Manager Home > SNMP > Common
menu (64101.01).
Press the [Refresh Product ID] button.
Check the message, then press [OK].