Advertisement
Attaching the plug to the
(1) Remove the outer
= NOTE ON FM/AM ANTENNA INSTAL-
cable up
to about
23mm
is tuner
nas
botn
an
Auto
Search
type tuning system
m
CONNECTING
THE
FM ANTENNA
(1"") me
the end, and
with 100kHz tuning steps on FM and 10kHz steps on AM
Choose an FM antenna thar Is appropriate to the local
id
center
©
Se
ee
ae
and a Manual tuning system, Normally, with stations
reception conditions. Consider the distance from the
conductor
peata prain
E ne on
stronger than 10uV (3004V/m on AM when using the
broadcast station and possible interfering objects such as
Plug section";
axial cable into its hole
in
loop antenna),
Auto
Search tuning can be used to find
surrounding tall buildings. In cases where there is a strong
==
the plug section, place the
and tune in stations automatically, Weaker stations may
signal from a local station, a portable T-type antenna is
Shield holder
—+
ees
hy ae shield
be tuned in with Manual step tuning. Extremely weak
usually adequate. Connect the feeder wire to the 300 ohm
(1)
ad
did
stations, however, will not be heard due to the action of
terminal, stretch the wire out tight, and turn the antenna
(2) Screw on the tightening
'the muting circuit,
In this case, try rechecking the
to obtain optimum reception, Attach to a suitable
|
sleeve,
antenna connections and adjusting the location, direc-
support such as a wall,
Gan toreendueier
tian and height of the antenna to increase the signal
æ
CONNECTING
TO THE AMPLIFIER
Use the cable supplied to connect the OUTPUT jacks of
the tuner to the input jacks of your amplifier, being sure
to observe the left and right channel markings. Also make
Coaxial cable
stations.
rotate the antenna
in its bracket for best reception. The
loop antenna may also be removed and hung on the wall.
If necessary,
an
outdoor
antenna
may
be used
for
With 300 ohms
improved
AM
reception,
Connect
a 5—10
meter
long
flat twin-lead.
insulated wire to the AM
Ant terminal and run it out-
SETA
doors.
Please confirm that the following accessories are included,
Coaxial cable plug
(75 ohms)
The loop antenna
may also be
removed and hung on the
wall.
With 75
ohms
.
a
coaxial
(deals ATA,
cable
=
1. Clip to rear panel,
in all but the best reception conditions, an outdoor
FM
antenna is necessary for best results. Either a 300 ohms
flat twin-lead
wire or a 75 ohms coaxial
cable may
be
used.
In locations where electrical
interference
is a
problem a coaxial cable is preferable. Refer to the figure
for instructions on installing the coaxial cable plug.
FM T-type antenna
(300 chms)
2. Try changing the direction
of the loop antenna,
Advertisement
