Configuring The Hotwire Adsl/R Bridge/Router - Paradyne Hotwire 6381 Install Manual

Dsl/r bridge/router with inline phone filter

Hide thumbs Also See for Hotwire 6381:

Table of Contents

Configuring the Hotwire ADSL/R Bridge/Router

STOP. Do not proceed with this section unless you were so instructed by your

Internet Service Provider (ISP), or you are familiar with IP and routing protocols.

Depending on the requirements of your ISP, your Hotwire ADSL/R Bridge/Router may

have a web interface that you can access using a web browser such as Internet Explorer

or Netscape. The web interface is used to configure the router.

Procedure

To configure the router using the web interface:

1. Start your web browser on a PC that is connected to the router directly or through

your hub.

Type the following into your web browser's address line:

http://192.168.1.1:8080

Press Enter. The Login screen appears.

Enter the password provided to you by your ISP. (This is admin if your ISP uses the

factory default.) The Basic Setup screen appears.

Enter and select the parameters according to the instructions provided by your ISP.

Click on Save.

Table of Contents

Do you have a question about the Hotwire 6381 and is the answer not in the manual?