Inserting The Card - Paradyne Hotwire 5100 User Manual

Inserting the Card

5100-A2-GB21-00
Procedure
To install your HotWire DSL card into your PC:
CAUTION:
This modem card is intended to be installed in UL Listed CSA Certified
equipment in the field by the user in the manufacturer's defined
operator access area. Check the equipment operating/installation
instructions and/or equipment manufacturer to verify/confirm if your
equipment is suitable for user-installed application cards.
1. Turn Off the PC. Disconnect cables for the monitor and any powered
equipment to the PC. Then, lay the PC chassis on a flat surface.
2. After waiting at least one minute, remove the PC cover and touch the metal
PC frame to discharge any static electricity on your clothes or body.
CAUTION:
Plugging in and turning on the system at the wrong time could result in
an electrical shock to you or cause damage to your computer system's
components.
3. Choose an unused 16-bit expansion slot
for the card.
4. Unscrew and remove the slot cover
panel, if present.
November 1996
Installation and Setup
8-Bit
16-Bit
ISA Expansion
ISA Expansion
Card Slot Card Slot
495-14661
496-14966
2-7