Table of Contents
Advertisement
Writing the RC Time Code on a Recorded Tape
You can write the RC time code on a recorded tape. Use the Remote Commander.
(
1
)
While pressing the small green button on the POWER switch, slide it to VTR.
(
2
)
Rewind the tape to
the beginning and set the camcorder to playback pause mode.
(
3
)
Press TIME CODE WRITE on the
Remote Commander. The TIME CODE WRITE indicator appears in the viewfinder with WRITE flashing.
(
4
)
Press E> or II to start playback. The WRITE indicator stops flashing and the RC time code writing
starts from 0:00:00:00.
To Stop Writing the RC Time Code
Press □ (or any tape transport button).
To Write the RC Time Code from the End of the RC Time Code Recorded Portion
Rewind the tape to the portion on which the RC time code has been written and set the camcorder to
f-I'i•T.ll L'J | ift't
| ifil il (T) |
r-A
iT« w
I
AW < 1
i h (hi iT*.*JI 1 t I 111 MU-14*i
Canceling RC time code writing
The RC time code writing stops when:
• you press TIME CODE WRITE again before starting playback
• you press INDEX before starting playback
• you change from playback mode to another mode
Notes on writing the RC time code
• When you are writing the RC time code from the middle of a tape without the time code written,
writing starts several frames before the current picture.
• You can not write the RC time cord on the tape recorded in LP mode. Though you can write it on the
tape recorded in mixed LP and SP modes, it may not be displayed correctly when the tape is played
back.
Advertisement
Table of Contents
