Table of Contents
Advertisement
Aligning the machine
The machine must be perfectly level to
ensure safe and proper operation.
^ The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The ventilation slots underneath
the door must on no account be
blocked as this will prevent a
sufficient intake of cold air.
Room in which the dryer is located
Air taken in for use in the drying
process will be warm when it is
expelled from the front of the dryer. This
expelled air heats up the air in the
room. It is therefore very important to
ensure that the room is adequately
ventilated, particularly if the dryer is
located in a small room. Otherwise
running times and energy consumption
could be increased.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. To do
this the appropriate stacking kit* (WTV)
to match your washing machine is
required.
A washer and dryer should never be
stacked without using the proper
stacking kit. Doing so is extremely
dangerous, as the dryer may vibrate off
of the washing machine during use.
,
All parts marked * are available
from the Miele Spare Parts or Sales
Departement, and must be fitted by
a suitably competent person
according to the instructions
supplied with the kit.
Before moving the machine again
After each use a small quantity of
condensed water will collect in the area
of the pump. This water can run out, if
the machine is tipped up when it is
being moved. We therefore recommend
that you run the "Cool air" programme
for approximately 1 minute before
moving the machine. Any remaining
condensed water will then be fed into
the condensed water container or out
through the drain hose.
Installation
37
Advertisement
Table of Contents
