Table of Contents
Advertisement
3.8.4
Break in operation
Notice
Batteries discharge if they are not used. If the
battery is stored for a longer period of time when
empty, it can become damaged and its storage
capacity can be greatly reduced.
Store battery with at least 30% charge.
Charge battery every six months.
Charge LED on the Remote or System
Controller via the USB diagnostic interface for
about an hour every three months.
The battery may become damaged if it is
connected permanently to the charger.
Never connect the battery to the charger
permanently.
Remove the on-board computer and battery
from their mount if the pedelec is not going to
be used for up to four weeks.
If the pedelec is removed from service for
longer than four weeks, you need to prepare it
for a break in operation (see Section 3.8.4.1).
MY23I0a - 42_1.0_22.01.2024
3.8.4.1 Preparing for a break in operation
1 The pedelec needs to be cleaned with a damp
cloth and preserved with wax spray. Never wax
the friction surfaces of the brake.
2 Have the specialist dealer carry out
maintenance and basic cleaning and apply
preservative agent before longer periods
without use.
3 Remove battery (see Section
6.7.2.1).
4 Charge battery between 30% and 60% so that
two or three LEDs light up on the battery level
indicator.
3.8.4.2 Carrying out a break in operation
1 Store the pedelec, battery and charger in a dry,
clean environment. We recommend storing
them in uninhabited rooms with smoke alarms.
Dry locations with an ambient temperature
between 10 °C and 20 °C are ideal.
2 Check the battery level after 6 months. If only
one LED on the battery level indicator lights up,
recharge the battery to around 30%–60%.
Transporting and storing
6.7.1.1
or
97
Advertisement
Table of Contents
