GE Moffat Series Owner's Manual page 19

Troubleshooting tips ... Before you call for service
Problem
Suds in the tub
Detergent left in dispenser
cups
Black or gray marks
on dishes
Dishes don't dry
Long cycle times
Control panel responded
to inputs but dishwasher
never filled with water
29-6273
Possible Cause
Wrong detergent.
Rinse agent was spilled.
Dishes or utensils are blocking
the detergent cup.
Aluminum utensils have rubbed
against dishes.
Low inlet water temperature.
Rinse agent dispenser is empty.
Additional drying time is
needed.
Cycle selection.
Cycle completion.
Dishwasher washes by
alternating mid and lower spray
arms.
Soil level.
Door may not be completely
closed.
Water valve may be turned off.
Flood float may be stuck.
What To Do
sudsing. Finish Quantum
® ®
Detergent has been approved for use in all GE
Appliances dishwashers.
To remove suds from the tub, open the dishwasher and
and hold Start for 3 seconds, and close the door. Repeat
if necessary.
Always wipe up rinse agent spills immediately.
Reposition the dishes, so the water from the lower spray
arm can flush the detergent cup. See the Loading
section. Reposition the tall utensils or heavy silverware
that may be keeping the dispenser cup door from
opening. See the Loading section.
Remove marks with a mild, abrasive cleaner.
Select Heated Dry or Dry Boost.
Wash Temp Boost.
Check the rinse agent dispenser and fill as required.
models).
Note:
cancelled.
If using Light cycle which uses lower water temperature
and thus limited dry performance, switch to a different
cycle.
this TROUBLESHOOTING TIPS section.
performance, let cycle complete.
The turbidity sensor senses how much soil is on the
dishes. Heavy soiled dish loads will add more time to
performance, allow cycle to complete.
Make sure the door is firmly closed.
Make sure water valve (usually located under the sink) is
turned on.
the ultra fine filter that looks like a salt shaker. Replace
the filter
Automatic Dishwashing