TILSBERK HUD User Manual page 32

13. Attach the TILSBERK HUD module to the helmet adapter using the magnets and fold down the display
at a 45° angle.
The display should be well visible in front of your right eye.
14. Push the operating button on the TILSBERK HUD module to switch on the device.
A screen appears on the display.
15. Check if you can clearly see everything on the display in its entirety without
You can show the frame again for alignment orientation at any time. To do so,
activate "Alignment mode" in the "My device" menu.
16. If the display is fuzzy or hard to read, you can change the angle of the display slightly.
17. If the frame shown on the display is fully or partially outside your field of vision, remove the
TILSBERK HUD module and the helmet adapter from the helmet and slightly move the helmet adapter
in the desired direction.
Shortly after mounting, the Sugru has not yet developed its full adhesive
power. The helmet adapter can be removed easily and then attached again.
If the layer of Sugru changes shape when the helmet adapter is removed from
the helmet, flatten it with your fingers prior to re-mounting.
18. Always recheck the conditions listed in step 15 and keep adjusting the position of the helmet adapter
until all conditions are met.
changing the position of the helmet on your head. To do so, look ahead as
you would if you were riding in traffic:
/ / The display should be well visible in front of your right eye.
/ / The display should be clear and easy to read.
/ / The entire screen should be within your field of vision. Use the frame for
orientation when switching on the TILSBERK HUD module.
I N - H E L M E T I N STA L L AT I O N
EN
EN
32