Table of Contents
Advertisement
I/O DEVICE EDIT window
This window is displayed when you select and press the wireless device in the I/O DEVICE
window (WIRELESS page). Set the channel name, GAIN, and other settings. These settings
cannot be configured when the console is offline. The settings in the device are applied when
the device is online.
For Shure AXT400
1
2
3
4
5
6
7
8
9
0
1
This indicator
lights up when there is a connection via a ShowLink® remote
control.
2
Device ID button (transmitter)
Press this button to open the NAME window to set the device ID for the transmitter. You
can enter up to 8 characters.
3
TX.GAIN knob
Sets the gain for the transmitter. To adjust the value, press the knob to select it, and use
the multifunction knobs (for CL series consoles) or the TOUCH AND TURN knob (for CL/
QL series consoles).
4
TX.GAIN
Indicates the gain value for the transmitter.
A
B
5
Channel name (receiver)
Press this button to open the NAME window to set the channel name for the receiver. You
can enter up to 8 characters. The channel name that is set on the transmitter is displayed.
6
Frequency
Indicates the frequency that is currently set for the RF signal.
7
RX.LEVEL knob
Sets the gain for the receiver. To adjust the value, press the knob to select it, and use the
multifunction knobs (for CL series consoles) or the TOUCH AND TURN knob (for CL/QL series
consoles). The level meter located at the immediate right of the knob indicates the input level.
8
MUTE button
Mutes the audio signal for the receiver.
9
RF (Radio Frequency) signal meter
Shows bars to indicate the level of the RF signal (A/B channel).
An active antenna indicator is shown on the right side. It indicates which antenna is enabled.
NOTE
For details about the relationship between the number of bars and the actual strength of the RF
signal, refer to the manual from Shure.
0
Battery indicator
Shows bars to indicate the remaining battery power.
NOTE
For details about the relationship between the number of bars and maximum operation time, refer
to the manual from Shure.
A
Diversity Mode indicator
Indicates the status for Diversity Mode.
If Diversity Mode is not running, "Diversity Mode: off" is displayed.
B
PORT ASSIGN tabs
Select these tabs to switch between the windows that specify the ports where the actual
input signals are assigned.
6
Support for Shure AXT400, QLXD4 and ULXD4
V4.1 Supplementary Manual
Advertisement
Table of Contents
