Random Tapeprogramming - Yamaha CDC-685 Owner's Manual

The unit will automatically program tracks on a disc in
random sequential order for recording to tape.
2
3
ill Follow steps 1 - 3 on page 17.
PJ Press the RANDOM button.
RANDOM
V
The unit will automatically program tracks for side A
and side B separately considering the tape's total time.
* The programmed track numbers and the total number
of tracks for side A and B are displayed for a short
time.
[] Start recording on the tape deck and press the
button at the same time.
"P.JThe unit will pause at the end of side A of the
tape.
Turn the tape over to side B. Resume recording and, at
the same time, press the _ or 00 button.
• Because the programmed data changes eve1T time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
• It is recommended that you use a tape that is slightly longer
in length than tile CD you are recording, because the
programmed tracks on a CD may not fit properly into the
time allowed on each half of the tape.
• CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in steps 3 and 4, press the SYNCHRO button
mid then press the _ button. Recording automatically begins.
(For details, refer to page 16.)
Display information during programming
(I) Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished,
and then it is replaced by the number of the first
programmed track for side A.
@ Shows the total time of programmed tracks for each side.
@ Shows the programmed track numbers for each side.
E-20