Download Print this page

Yamaha LMY2-MLAB Manual

I/o cards
Hide thumbs Also See for LMY2-MLAB:

Advertisement

Quick Links

T
hank you for choosing the Yamaha input card for the analog input box AI8, and the Yamaha output card for the analog
output box AO8.
Be sure to ask an authorized Yamaha service engineer to install the cards. Do not install the cards yourself.
The connecting screw also functions as the ground. Secure the screw tightly.
の度はヤマハ アナログイ ンプッ ト ボッ クスAI8用イ ンプッ ト カー ド、 アナログアウ ト プッ ト ボッ クスAO8用アウ ト プッ ト カー ドをお買上げいただき、
ありがと う ございます。
カー ドの取付けは、 必ずヤマハサービスエンジニアにご依頼く ださい。 お客様ご自身では行なわないでく ださい。
接続ネジはアース兼用ですのでしっかり締めてあるか確認してく ださい。
■ LMY2-MLAB
This is a two-channel analog input card. Set the input level in the
range of –68 dB to +10 dB.
You can install up to eight cards in the analog input box AI8.
PM1D system software prior to V1.70 recognizes this card as
LMY2-ML. However, the card will function properly.
2チャ ンネルのアナログ入力カー ドです。 入力レベルは−68 dB∼+10dB
の範囲で設定します。
アナログイ ンプッ ト ボックスAI8に8枚まで装着できます。
PM1D V1.70よ り前のシステムソフ ト ウェアでは、 カー ド名が 「LMY2-ML」
と表示されますが正しく 動作します。
Input
GAIN***
Terminals
–68 dB
CH1A, CH1B
CH2A, CH2B
+10 dB
* 0 dBu is referenced to 0.775 Vrms.
+48VDC (phantom power) is individually supplied to each input connectors. AD Conversion: 24 bit linear +4 bit floating, 128 times oversampling.
+48VDC (フ ァンタム電源) が各入力端子にそれぞれ供給されます。 ADコンバージ ョ ン : 24ビッ ト リニア +4ビッ ト フローティ ング、 128倍オーバーサンプリ ング
■ LMY4-MLF
This is a four-channel analog input card. Set the input level in the
range of –68 dB to +10 dB.
You can install up to eight cards in the analog input box AI8.
PM1D system software prior to V1.70 recognizes this card as
"Unknown" and cannot communicate with it. Be sure to use this
card with PM1D V1.70 or higher.
4チャ ンネルのアナログ入力カー ドです。 入力レベルは−68 dB∼+10dB
の範囲で設定します。
アナログイ ンプッ ト ボックスAI8に8枚まで装着できます。
PM1D V1.70よ り前のシステムソフ ト ウェアでは、 カー ド名が 「Unknown」 と
表示され、 お使いいただけません。 必ずPM1D V1.70以上のシステムでお
使いく ださい。
Input
GAIN***
Terminals
–68 dB
CH1–4
+10 dB
* 0 dBu is referenced to 0.775 Vrms.
+48VDC (phantom power) is individually supplied to each input connectors. AD Conversion: 24 bit linear, 128 times oversampling.
+48VDC (フ ァンタム電源) が各入力端子にそれぞれ供給されます。 ADコンバージ ョ ン : 24ビッ ト リニア、 128倍オーバーサンプリ ング
I/O cards
ANALOG INPUT BOX
ANALOG OUTPUT BOX
MIC/LINE INPUT CARD
AD CARD
DA CARD
Actual Load
For Use With
Impedance
Nominal
50–600 Ω Mics
3 kΩ
& 600 Ω Lines
** 1=GND, 2=HOT, 3=COLD
Actual Load
For Use With
Impedance
Nominal
50–600 Ω Mics
3 kΩ
& 600 Ω Lines
** 1=GND, 2=HOT, 3=COLD
for
LMY2-MLAB, LMY4-MLF
LMY4-AD
LMY4-DA
When the indicator is lit in orange,
channel B is selected. When the indicator
is turned off, channel A is selected.
点灯時 (オレンジ) はチャンネルBが選択、
消灯時はチャンネルAが選択
Input Level
Nominal
–68 dBu (309 µV)*
+10 dBu (2.45 V)*
*** The GAIN control level displayed on the CS1D.
The green LED lights up at 34 dB before clipping.
クリッピング手前34dBで緑色LEDが点灯
Input Level
Nominal
–68 dBu (309 µV)*
+10 dBu (2.45 V)*
*** The GAIN control level displayed on the CS1D.
The green LED lights up
at 34 dB before clipping.
クリッピング手前34dBで
緑色LEDが点灯
Connector
Max. Before Clip
–54 dBu (775 µV)*
XLR-3-31 type
(Balanced)**
+24 dBu (12.3 V)*
Connector
Max. Before Clip
–54 dBu (775 µV)*
XLR-3-31 type
(Balanced)**
+24 dBu (12.3 V)*

Advertisement

loading

Summary of Contents for Yamaha LMY2-MLAB

  • Page 1 Yamaha input card for the analog input box AI8, and the Yamaha output card for the analog output box AO8. Be sure to ask an authorized Yamaha service engineer to install the cards. Do not install the cards yourself.
  • Page 2 For Use With Nominal +10 dBu (2.45 V)* 150 Ω 600 Ω Lines +1 dBu (870 mV)* ** 1=GND, 2=HOT, 3=COLD U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation SIGNAL SIGNAL SIGNAL AD CARD ANALOG IN MODEL LMY4-AD The green LED lights up at 34 dB before clipping.
  • Page 3 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

This manual is also suitable for:

Lmy4-adLmy4-daLmy4-mlf