Page 1
Tio1608-D I/O RACK Owner’s Manual Bedienungsanleitung Mode d’emploi Manual de instrucciones Manual do Proprietário Manuale di istruzioni Руководство пользователя 取 扱 説 明 書 AUDIO INTERFACE...
Page 2
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. AVERTISSEMENT POUR RÉDUIRE LES RISQUES D’INCENDIE OU DE DÉCHARGE (UL60065_03) ÉLECTRIQUE, N’EXPOSEZ PAS CET APPAREIL À LA PLUIE OU À L’HUMIDITÉ. (UL60065_03) - 2 - Tio1608-D Owner’s Manual...
Page 3
Yamaha Corporation of America or its subsidiaries. operation of other electronic devices. Compliance with FCC * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B) IMPORTANT NOTICE In Finland: Laite on liitettävä...
This symbol is only valid in the European Union. Model No. If you wish to discard these items, please contact your local authorities or dealer and ask for the Serial No. correct method of disposal. (weee_eu_en_01) (rear_en_01) - 5 - Tio1608-D Owner’s Manual...
If you intend to use the device in an area other than in the one you purchased, the included power cord may not be CAUTION compatible. Please check with your Yamaha dealer. • Check the electric plug periodically and remove any dirt or Always follow the basic precautions listed below to dust which may have accumulated on it.
Page 7
If there is reason to believe that condensation might have occurred, Yamaha cannot be held responsible for damage caused leave the device for several hours without turning on the by improper use or modifications to the device.
Introduction Precautions when Thank you for purchasing the Yamaha Tio1608-D I/O rack. The Tio1608-D is an I/O rack that features 16 channels of rackmounting analog inputs and 8 channels of analog outputs. In order to take full advantage of this product's features, and...
Nominal output level is +4 dBu. See "Connection methods" (page 13) for information about Quick Config. - 9 - Tio1608-D Owner’s Manual...
Page 10
Device features [SYSTEM] indicators Indicate the status of the Tio1608-D. During normal operation, the green indicator is lit and the red indicator is off. When the unit is turned on, if the green indicator is off and the red indicator is lit or is flashing, an error has occurred.
7 and 8. Switch Initialize mode position Initialize mode is off (unit will not be reset when it is turned on) Initialize mode is on (unit will be reset when it is turned on) - 11 - Tio1608-D Owner’s Manual...
Page 12
SECONDARY connectors. If an indicator is lit, the corresponding connector is connected to a Gigabit Switch Start up mode Ethernet network. position Refresh mode (normal operation) Resume mode (normal operation) Update mode - 12 - Tio1608-D Owner’s Manual...
[SECONDARY] Dante connector. Quick Config makes it easy to set up the unit automatically. When connecting 3 units It allows you to connect up to three Tio1608-D units to one TF series mixing console, and configures Dante network [PRIMARY] or settings and audio signal settings in one operation.
Connection methods 7. To assign the Tio1608-D inputs to the TF series Manual setup mixing console, set the input select on the console's INPUT screen to "SLOT". You can configure your devices manually if you do not want to use Quick Config.
Internal head amp gain is too low. appropriate level. DIP switches are set to "refresh" Start the device that will control the Tio1608-D mode but device that controls the and send the settings to the Tio1608-D. Tio1608-D has not started up.
[SYSTEM] Indicators Description Possible Solution Internal Dante error has occurred. The unit is malfunctioning. Please contact your nearest Yamaha representative. Flashes 2 times MAC address setting is damaged and Dante communication is not possible. Flashes 3 times Duplicate UNIT ID was found.
Page 17
45 seconds for completion. Waiting to receive setting data. If START UP MODE is set to REFRESH on the Tio1608-D unit, the input/output will be muted until the unit receives setting data after it starts up.
Specifications Specifications General Specifications Output impedance of signal generator: 150ohms Measured with another Tio1608-D through Dante network. Frequency Response Fs = 44.1kHz or 48kHz, 20Hz-20kHz, refer to the nominal output level @1kHz Input Output Conditions Min. Typ. Max. Unit INPUT1-16 OUTPUT 1-8 600Ω...
* Der Inhalt dieser Bedienungsanleitung gilt für die neuesten technischen Daten zum Zeitpunkt der Veröffentlichung. Um die neueste Version der Anleitung zu erhalten, rufen Sie die Website von Yamaha auf und laden Sie dann die Datei mit der Bedienungsanleitung herunter.